Napco Security Technologies IBR Manuel D’Utilisation

1

 

© NAPCO 2018 

WI2297LF 

preliminary draft # .25

  4/18 

 Unpack the touchscreen tablet 

(

look carefully for the sup-

plied mounting hardware; the Power Adapter is only included with
the model IBR-TOUCH-WL

)

Note:  If using older ISEE Series Cameras, use your existing
ISEE-WAP (with its power adapter and CAT5 cable, shown).

Mount the touchscreen rear case to the wall using 
screws appropriate for the mounting surface.   
Power must be provided with the IBR-TOUCH-WL 
using the 12VDC power adapter, observing polarity 
(use the wire hole located in the center of the rear 
case, shown below).  The IBR-TOUCH connects 
to the Gemini security system 4-wire bus. 

Apply power to the control panel, the touchscreen 
and the ISEE-WAP / IBR-ZREMOTE / StarLink 
Connect radio.  Upon power up, both touchscreens 
will start within about 5 seconds (both can be manu-
ally powered by pressing and holding the small but-
ton on the right side for 10 seconds).  

Upon power up, the Setup Wizard will automatically 
start.  Follow the sequence of images as shown in the 
following steps, as necessary for the in-
stallation type.  

If the Setup Wizard does 

not automatically start, press and hold 
the  System Settings ("gear") icon, enter 
your Dealer password, then tap Setup 
Wizard.  

"center hole" for 
power or keypad bus 

wires 

Tap  Yes  and set the date, time and Time Zone (if 

necessary).  IMPORTANT:  Outdated digital certifi-
cates will disallow connection to your iBridge or 
StarLink Connect system, as well as inhibiting nec-
essary automatic firmware downloads.   

Wait for the system diagnostics process to complete. 
Functional components are marked with a check; 
items not configured or not enabled are marked with 
a "x".  Selections are blank when the Setup Wizard is 
run for the first time.  Tap Configure to continue.  

. .