Taiyo Co. Ltd. A40827 Manuel D’Utilisation

Page de 16
English
14
H ow to make a successful landing
(5) After landing the airplane, turn off the airplane switch and the transmitter (charger) switch, in that order.
(6) Remove the battery pack from the airplane, and unplug the connector.
Airplane Maintenance (Repairs)
* If mud enter into the airplane or stuck to it near the tail assembly, the center of gravity of the airplane may change. Therefore, be sure
to clean the plane as needed.
* If the airplane is badly damaged, it may become unbalanced and cannot fly properly. Please have it repaired by customer service. (For
more details, read the "About after-sales service" section.)
* Daily maintenance extends the life of the airplane. If grass or mud is stuck on the airplane, be sure to remove it all. Check each section
of the plane for looseness.
* Since the airplane is made of EPP material that is difficult to break and is very flexible, some paints may peel off easily. Please note
this possibility.
* When you are through flying
the airplane, be sure to col-
lapse the transmitter antenna.
Landing is complete
Gliding condition
(preparing to land)
Speed up and keep the
airplane level.
Stop the propellers. Keep adjusting
the left-and-right tilt of the airplane
while it descends.
1 m
Stop
* Although the airplane may seem difficult to control the airplane at first, do not give up. Read the manual carefully
and practice.
(5)
(6)
Power switches
A
408-
English
A408
14
Direction to Change the Propeller
1. Pull the propeller cap while widening on left and right side. 
2. Take off nut by using pliers (Turn to right side), than take off washer. At last take the propeller off. 
3. Please be careful installing propeller, flat portion of the propeller is to face front of the airplane. Please refer to direction #1 and 
  #2 for assembly.
  
Other Maintenance
* If the body of the airplane is broken, please use glue for "Styrofoam."
* If the rudder hinge comes off, please use very thin double-sided tape to repair. 
* If the vertical rudder hinge is broken or lost, please use clear film from the package. Cut clear film into 8mmx18mm and use it
   to repair. 
* If the rudder horn comes off from the shock of landing or other, please use high viscosity type of glue to repair.