Tenetics LLC GW2 Manuel D’Utilisation
Location/Mounting
The gateway can be wall mounted or placed on any flat surface. Pick a
location near an AC outlet and your WiFi Access Point/Router.
location near an AC outlet and your WiFi Access Point/Router.
For wall mounting, use two 1/8” (#5) screws. If mounting to drywall,
use appropriate drywall anchors spaced 4.65” apart.
use appropriate drywall anchors spaced 4.65” apart.
Once the location is chosen and the gateway is mounted, carefully thread
the provided antenna onto the gateway antenna connector until it is
finger tight. Do not overtighten.
the provided antenna onto the gateway antenna connector until it is
finger tight. Do not overtighten.
Pro Tips:
* Mount indoors away from wet locations
* The antenna should be vertical
* Don’t put the antenna near metal objects
* Locate the gateway where it has an unobstructed view of your fields
* Mount indoors away from wet locations
* The antenna should be vertical
* Don’t put the antenna near metal objects
* Locate the gateway where it has an unobstructed view of your fields
Installation is as easy as 1,2,3
1. Plug the AC power adapter into the wall and connect it to your
gateway using the USB A to mini-B cable. The blue light on the
gateway will start blinking.
gateway will start blinking.
2. Press and hold the WPS button on your WiFi Access
Point/Router for a few seconds to enable connecting a new
device to your network (for the exact process, consult your
Access Point manual). Typically, a light on your Access Point
will start blinking.
device to your network (for the exact process, consult your
Access Point manual). Typically, a light on your Access Point
will start blinking.
3. Press the WIFI button on your gateway. After 10-60 seconds,
the blue light should stop blinking and stay on steadily to show
that the gateway is connected to the internet.
that the gateway is connected to the internet.
That’s all there is to it, you’re done!
Sensors Tab
The sensors tab
shows the most
recent readings
from each remote
sensor.
shows the most
recent readings
from each remote
sensor.
Press the refresh
button to update the
display.
button to update the
display.
System Tab
The system tab shows
the status of the
gateway and allows you
to:
the status of the
gateway and allows you
to:
•
change the
gateway name
gateway name
•
set the time
zone
zone
•
enable the
receive filter
for areas with
radio
interference
receive filter
for areas with
radio
interference
2
7