Vivint. Inc. AP03 Manuel D’Utilisation
SR1530 Installation and User Guide
Page 13
SR1530 Installation & User Guide
Ver. 0.01
System Setup
The SR1530 is setup by the Vivint professional installer/technician.
1.4 Administration
1.4.1 Adding Users & Changing Password
The administration of the SR1530 is governed by the Vivint-NOC (Network Operations Center)
Usage: adduser [OPTIONS] user_name
Add an user
Options:
-h DIR Home directory
-g GECOS GECOS field
-s SHELL Login shell
-G GROUP Add user to existing group
-S Create a system user
-D Do not assign a password
-H Do not create home directory
Usage: passwd
Change password of an user
1.4.2 Upgrading Firmware
The SW/FW upgradation is governed by the Vivint-NOC (Network Operations Center) and the end-
user doesn’t have access to the device.
1.5 System
Log
/var/log/message keeps a circular log in memory, no filesystem activity involved.
1.5.1 Enabling System Logging
To read the logfile from syslogd you should use the logread command, which outputs the
messages in syslogd's circular buffer.
messages in syslogd's circular buffer.
Logging is always enabled.
1.
Mount the AP on its fixture without touching the pins of the Radio RJ45 connector.
2.
Patch cable from radio to Citel - Make a shielded CAT5e cable such that its shielding foil is grounded to the
metal shielding of the RJ45 connectors at either end as shown in slide#10
3.
Connect one end of the cable to the radio and the other end to the “IN” port on the Citel surge suppressor
4.
Use 12AWG wire to connect the surge suppressor center ground ping to building common ground
5.
Make another shielded CAT5e cable that has RJ45 shielded connectors at both ends. Connect one end to
the remaining RJ45 port on Citel suppressor, and the other end to the PoE injector as shown in slide #12
6.
Check for GND continuity as shown in slide#12
7.
Power up the PoE injector last
and check functionality
.