MC MOBILE E.U. AEROX Manuel D’Utilisation

 

22

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following measures: 

-- Reorient or relocate the receiving antenna.     

-- Increase the separation between the equipment and receiver.       

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.     

-- Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including 

interference that may cause undesired operation. 

 

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority 

to operate the equipment. 

 

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the 

emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the 

U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy 

for the general population. The guidelines are based on standards that were developed by independent scientific 

organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial 

safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard 

for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The 

SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest 

certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power 

level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the 

phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In 

general, the closer you are to a wireless base station antenna, the lower the power output. Before a phone model 

is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit 

established by the government adopted requirement for safe exposure. The tests are performed in positions and 

locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value 

for this model phone when tested for use at the ear is

 0.209W/Kg 

and when worn on the body, as described in this 

user guide, is 

. (Body-worn measurements differ among phone models, depending upon available 

accessories and FCC requirements). While there may be differences between the SAR levels of various phones 

and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an 

Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the 

FCC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under 

the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on 

 

Additional information on Specific Absorption Rates (SAR) can be found on the Cellular 

Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States 

and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of 

tissue. The standard incorporates a sub-stantial margin of safety to give additional protection for the public and to 

account for any variations in measurements. 

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum 

separation distance of 1.5 cm must be maintained between the user's body and the handset, including the antenna. 

Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic 

components. Body-worn accessories that do not meet these requirements may not comply with RF exposure 

requirements and should be avoided. Use only the supplied or an approved antenna.