Shenzhen Yuwei Information And Technology Development Co. Ltd. YW3000-XQ Manuel D’Utilisation
Normal power consumption
65mA (Power Saving Mode<15mA)
Working Temperature
-20°C ~+60°C
Working Humidity
5%~95% RH
GPS Antenna
GPS SMA connection
Interface
1 ignition input 7~60VDC
1 positive input 7~60VDC
1 relay output 500mA 12VDC
1 RS232 COM port
GSM Antenna information
Manufacturer
TOPPOINT TECHNOLOGY
Model
DDA-T800
Antenna Gain:
GSM850: 2.15dBi
PCS1900: 2.15dBi
PCS1900: 2.15dBi
Antenna Type:
Unique antenna(Revised SMA connector)
Main device and standard accessories:
-YW2211 main unit
-GPS antenna
-GSM antenna
- I/O/power combined cable
Optional accessories:
- Immobilization relay
- Emergency button
- Large capacity back-up battery
FCC RF Exposure Warning:
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 25 cm from all persons and must not transmit simultaneously with any other antenna or
transmitter.
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.