Fopoconn Electronic Co. LIMITED NETK4 Manuel D’Utilisation
31
1 After inserting the SIM card and memory card, install
the battery. The battery terminal of the battery bay copper
interface copper contact tip, then carefully placed in the
battery.
After the battery cover on the housing and push down
until it is completely fit with the phone.
2 Make sure the phone is turned off before removing the
battery. Lift up and remove the cover, lift up from the
lower end of the battery, and then remove the battery.
1.2 Battery Charging
Supplied fresh batteries have some margin of power,
we recommend that before you start using your
phone, install the battery and charging ahead. After
several full charge and completely exhausted
repeated use, battery performance will reach the
best condition. There are two ways to charge:
• Use the AC power cord to connect the phone and
power.
• Use the USB sync cable to connect your phone
and computer.
Tip: Use the supplied AC power cord and USB sync
the battery. The battery terminal of the battery bay copper
interface copper contact tip, then carefully placed in the
battery.
After the battery cover on the housing and push down
until it is completely fit with the phone.
2 Make sure the phone is turned off before removing the
battery. Lift up and remove the cover, lift up from the
lower end of the battery, and then remove the battery.
1.2 Battery Charging
Supplied fresh batteries have some margin of power,
we recommend that before you start using your
phone, install the battery and charging ahead. After
several full charge and completely exhausted
repeated use, battery performance will reach the
best condition. There are two ways to charge:
• Use the AC power cord to connect the phone and
power.
• Use the USB sync cable to connect your phone
and computer.
Tip: Use the supplied AC power cord and USB sync