LADD IP Holdings Pty Ltd atf BMT IP Discretionary Trust A310500V5R1 Manuel D’Utilisation
BMM
®
System
Manual
– BMM Activator
3
www.bmt.com.au
2.3
Test Button
The Test function only confirms that the BMM
®
is functioning by
turning it on briefly. It is not necessary to use this during normal use
and it is best to avoid using this function onsite.
and it is best to avoid using this function onsite.
If Test Mode has to be used to confirm a BMM
®
is functioning, position the activator as
previously described and press the grey
Test
button ❼ (the display ❹ can be any number).
The BMM
®
will then transmit for about five seconds and then turn off, ready to be switched
on normally.
2.4
Delayed Start-up
The BMM
®
transmits at constant power for about 10 – 12 hours so to accurately calculate the
depth of the BMM
®
s after the blast, they must be located within this period. The BMM
®
will
continue to transmit for about 24 hours beyond this time (total ~36 hrs) but the signal will
slowly decrease and eventually switch off. If the BMM
®
is located after the initial 10 hr period,
its horizontal location will be accurate but not its depth. The delayed start-up feature was
specifically designed for mines that could not access the muckpile immediately after blasting
specifically designed for mines that could not access the muckpile immediately after blasting
due to light and/or safety reasons. It can also be used to install the BMM
®
s well before the
blast for operational reasons.
Once activated with a delayed start-up, the BMM
®
with transmit for approximately 15
minutes before switching off and sleeping for the requested period. At the end of the delay
period, it will transmit normally until the battery goes flat – just as it does with zero delay.
Refer to the “Monitoring Procedure Manual” for more information about how the delayed
start may be used.
Delays can be set in multiples of 4 hours, up to 36 hours. The displayed number is the
period, it will transmit normally until the battery goes flat – just as it does with zero delay.
Refer to the “Monitoring Procedure Manual” for more information about how the delayed
start may be used.
Delays can be set in multiples of 4 hours, up to 36 hours. The displayed number is the
actual
delay in hour
s, which is different to the old Type 4 Activator.
WARNING
Once a BMM
®
is activated for delayed start-up it cannot
be changed. That is, it cannot be switched off nor be made
to switch on earlier or later.
to switch on earlier or later.
2.5
Miscellaneous
The BMM Activator is also useful to quickly determine if a BMM
®
is transmitting since the red
receive LED ❺ will illuminate intermittently with sound whenever a BMM
®
signal is
detected.