CEI Conrad Electronic International Limited RCL-RR8-TP Manuel D’Utilisation

Transmitter  |  15

Navigate and set:  
System > OK > Student mode > OK > OK > Yes/No > OK

In this mode, stick input is directly sent to the trainer’s transmitter and all student settings 
are bypassed. When the »Transmitter operates in student mode it must not be connected 
to any receiver. Follow the on-screen instructions to enable and disable the student mode.

The »Transmitter is equipped with a timer and counter function.

Navigate and set:  
System > OK > Timer Setting > OK > Timer > OK > UP/DOWN > OK (hold)

> Start timer: Press the key UP or DOWN until “Start” is displayed. Press and hold the key 

OK to confirm the input and start the timer. 

> Cancel timer: Press the key UP or DOWN until “Stop” is displayed. Press and hold the 

key OK to confirm the input and cancel the timer. At this stage, even after leaving the 
menu, the time is preserved and you may restart the timer anytime. If you wish to reset 
the time, press and hold the key CANCEL after cancelling the timer.

Navigate and set: 
System > OK > Timer Setting > OK > Counter > OK > UP/DOWN > OK >... 
> OK (hold)

1.  Select counting mode: For the timer to count up set it to “Up” and to count down to 

“Down”. Press the key OK to confirm the input.

2.  Set the counter time (max. 60 minutes) with the keys UP and DOWN. Press the key 

OK to confirm the input.

3.  Press the key UP or DOWN until “Start” is displayed. Press and hold the key OK to 

start the timer.

4.  When the preset time, depending on your settings, is reached or elapses, an audible 

alarm is emitted for a short time. Press and hold the key CANCEL to reset the time. 

> If you wish to prematurely cancel the counter, set “Start/Stop” to “Stop” and press and 

hold the key OK to cancel the counter. At this stage, even after leaving the menu, the 
time is preserved and you may restart the counter anytime.

> While the counter is running you can cancel the counter and reset the time at the same 

time by pressing and holding the key CANCEL.

The »Transmitter is equipped with an audible alarm function that notifies you after a preset 
time elapses, during which no switch, stick or key input was detected. 

Navigate and set: 
System > OK > Alarm Setting > OK > UP/DOWN > OK (hold)

1.  Set the alarm time (1 to 10 min.).
2.  Press and hold the key OK to confirm the input.

> Any switch, stick or key input restarts the counter.

> Any switch, stick or key input cancels the alarm and restarts the counter.

Navigate and set:  
System > OK > Firmware ver. > OK/CANCEL

The screen displays version and compilation date of the installed firmware.