Peerless-AV ADS100-A252 Manuel D’Utilisation
6 of 12
ISSUED: 10-07-13 SHEET #: 180-9052-1
Introduction
This instruction sheet is meant for adding additional amplifi ers to the base system and presume one
amplifi er is already set up and running per instructions provided.
amplifi er is already set up and running per instructions provided.
This wireless audio distribution system provides for 8 total independent mono zones, or 4 total stereo
zones, or any combination in-between. By connecting your source(s) to either the RCA line level
or speaker level inputs, you can wirelessly receive the audio signal and amplify it for the remote
speakers.
zones, or any combination in-between. By connecting your source(s) to either the RCA line level
or speaker level inputs, you can wirelessly receive the audio signal and amplify it for the remote
speakers.
The installation process starts with a little planning, understanding the options you have for
installation.
installation.
Installation Planning
There is much fl exibility in the component installations. The amplifi er/receiver also has installation
options including:
options including:
•
Inside a drywall cavity (fl ush to the outer surface). The maximum drywall thickness is 5/8”.
•
Attached to a structure, such as ceiling beams
•
On top of a wall surface (requires accessory kit ADS100-OWK)
It helps to have your amp locations in mind when starting the installation process. Generally the
amplifi er is placed near to a 120/240 VAC power source, capable of 150 watts peak demand.
amplifi er is placed near to a 120/240 VAC power source, capable of 150 watts peak demand.
Tip: While this device does not require Line-of-Sight, the signal still can be affected by certain
building materials. For best wireless performance, try to keep cement or a lot of steel (like ductwork
or a refrigerator) out of the imaginary Line-of-sight between transmitter and receivers.
building materials. For best wireless performance, try to keep cement or a lot of steel (like ductwork
or a refrigerator) out of the imaginary Line-of-sight between transmitter and receivers.
What’s In The ADS100-A252 Box
Before you start the installation, make sure you have the following items:
• ADS100-A252
Amplifi er Kit
Tools Needed For Installation
• Bubble
Level
• Phillips
Screwdriver
•
Small straight screwdriver
• Drywall
Saw
• Wire
Strippers
• Side
Cutters
• Tape
Measure
• Pencil
• Amplifi er In/On-Wall, 25X2, 120/240V
•
•
In-Wall Holder For Amp
•
In-Wall Bracket Screw For Amp
• Drywall
Clamp
• Conduit
Adapter
Bracket
•
2 Gang Oversize Wall Plate
• In-Wall
Amp
Template
• System
Instructions