LEEDARSON LIGHTING CO. LTD. 6ZY-A806ST-Q1Z Manuel D’Utilisation
User Manual
Please see the user manual before to set up the bulb.
The bulb is based on ZigBee protocol, realizing the function of on/off,
brightness dimming and CCT control. Also could be control by APP wirelessly.
1. Fit the bulb into the light fitting and switch the light on.
The bulb is based on ZigBee protocol, realizing the function of on/off,
brightness dimming and CCT control. Also could be control by APP wirelessly.
1. Fit the bulb into the light fitting and switch the light on.
Ensure the wall switch for the light is switched off before fitting the bulb.
Once fitted, switch the light on at the wall and the bulb will then flash on and
off to show that it is searching for you hub.
Once fitted, switch the light on at the wall and the bulb will then flash on and
off to show that it is searching for you hub.
2. Reset device: customer could rest the device through on/off 5 times the
device by physical button. After above operation light will flash which
means reset successfully.
means reset successfully.
3. OTA upgrade: user could use APP to upgrade the light, light will flash which
means upgrade successfully.
Remember: To turn your bulb on or off remotely it must be switched on at
the wall. The bulb should not be dimmed using a wall mounted dimmer
switch as it may cause buzzing or flickering.