Cinch Systems Inc RF-RDWS-AAA Manuel D’Utilisation
Wireless Recessed Sensor—Installation Instructions
Recessed Wireless Sensor and Accessories
1 - RF-RDWS-AAA 1 - RF-RDWS Magnet 1 - Battery
( CR2 3V)
Instructions
Doc # I-RF-RDWS-AAA Rev. A Sep 2015
Mounting the Transmitter:
1. Verify mounting location before drilling any holes,
1. Verify mounting location before drilling any holes,
the area must be able to accept an 11/16” hole to a
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
2. The holes must be drilled directly across from each
other to ensure the magnet and sensor operate
properly
properly
3. Using an 11/16” drill bit drill the hole for the magnet
first, after drilling the magnet hole mark the location
directly across for the sensor hole.
directly across for the sensor hole.
4. The magnet and sensor are slightly larger than the
drilled hole to ensure a snug fit, a small amount of
routing the hole may be required
routing the hole may be required
5. Push both magnet and sensor into mounting holes.
Programming:
1. Remove the cap from the sensor by using a screw-
Programming:
1. Remove the cap from the sensor by using a screw-
driver and twisting the cap
2. Pull the battery tab out to power the sensor
Note: The sensor should
be mounted in the door
and the magnet in the
frame.
be mounted in the door
and the magnet in the
frame.
Carefully pull out battery tab to power the sensor
Mount in
top or side
of door
top or side
of door
Wireless Recessed Sensor—Installation Instructions
Recessed Wireless Sensor and Accessories
1 - RF-RDWS-AAA 1 - RF-RDWS Magnet 1 - Battery
( CR2 3V)
Instructions
Doc # I-RF-RDWS-AAA Rev. A Sep 2015
Mounting the Transmitter:
1. Verify mounting location before drilling any holes,
1. Verify mounting location before drilling any holes,
the area must be able to accept an 11/16” hole to a
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
depth of 2 1/4” for the sensor and 5/8” for the mag-
net
2. The holes must be drilled directly across from each
other to ensure the magnet and sensor operate
properly
properly
3. Using an 11/16” drill bit drill the hole for the magnet
first, after drilling the magnet hole mark the location
directly across for the sensor hole.
directly across for the sensor hole.
4. The magnet and sensor are slightly larger than the
drilled hole to ensure a snug fit, a small amount of
routing the hole may be required
routing the hole may be required
5. Push both magnet and sensor into mounting holes.
Programming:
1. Remove the cap from the sensor by using a screw-
Programming:
1. Remove the cap from the sensor by using a screw-
driver and twisting the cap
2. Pull the battery tab out to power the sensor
Note: The sensor should
be mounted in the door
and the magnet in the
frame.
be mounted in the door
and the magnet in the
frame.
Carefully pull out battery tab to power the sensor
Mount in
top or side
of door
top or side
of door