NINGBO DIYA ELECTRIC APPLIANCE CO. LTD. DR-011 Manuel D’Utilisation

Wireless RF Remote Control System

DR-1751

Hand Held Transmitter

DR-1691

and 3 pcs Plug-in Receiver

DR-1692

Feature:

Imagine turning on your house lights from inside your car. Or turning off your stereo from

across the room. This wireless Radio Frequency (RF) control now makes it possible. RF Controls

are an easy, convenient way to remotely control lights, and appliances in and around your home

or office. The invisible RF signal passes through walls, doors, ceilings, floors and even around

corners. Simply plug the desired appliance into the receiver and the receiver into any outlet. A

press of the button on the hand held transmitter, turns whatever you‚ve plugged into the receiver

on or off.

CAUTION

1: The total load of appliances connected to the Plug-in Receiver should not exceed 1875 Watts or

15 Amps resistive, or 625Watts or 5 Amps tungsten.

2: Do not use Plug-in Receiver to control appliance loads that may be dangerous to turn on

remotely (i.e. power tools).

3: The Plug-in Receiver must be located within 100 feet Transmitter.

Step1: Remove plastic battery tab by gently pulling it from the battery compartment (this tab

isolates the battery until it’s ready for use and insures that you’ll have a fresh battery).

Step2: Pairing .Your transmitter and receiver had been paired before shipped ,if you would like to

replace any of receiver/transmitter ,please go to “Step 2A” procedure .if not ,please go to Step 3

Step2A: Plug the Receiver into any standard grounded 120 Volt outlet being careful to match the

wide blade of the Receiver with the wide slot on the outlet. Fully insert.

Step2B: Remove paired

1. Press and hold the power button for 5 seconds until the LED indicator begins to flash slowly.
2. Press and hold the power button for an additional 5 seconds until the LED indicator begins to

flash rapidly .

3. Press the power button once to confirm to remove all paired transmitter from your receiver
Step2C: Pairing transmitter and receiver. pairing will be saved for 1 year without power supply

1. Our remote control units include a unique pairing feature that allows you to control multiple

receivers from the same transmitter ,or to control same receivers from multiple transmitter .

2. Press and hold the power button on the receiver for 5 seconds until the LED indicator begins

to flash slowly, indicating pairing mode has been activated .

3. Press “ON” button ,then “OFF” button on your transmitter to complete the pairing process .
Repeat Step2A-2C to pairing 2

and 3

ON/OFF switch with receivers ,or multiple transmitter

and receiver.

Step2D: unplug receiver.

Step3: Plug your light/appliance into the outlet on the Receiver being careful to match the wide

blade of the light/appliance (if equipped) with the wide slot on the outlet.

Step4: Plug the Receiver into any standard grounded 120 Volt outlet being careful to match the

wide blade of the Receiver with the wide slot on the outlet. Fully insert.