Mesh Systems LLC DS003 Manuel D’Utilisation
P a g e
| 11
Version 1.0
DOW CONFIDENTIAL - Do not share without permission
Section 3.2: Component List
Image
Quantity
Description
Comments
1
ActiveSense Hub
1
Power Supply
1
Hub Stand
1
ActiveSense Activator Tool
1 to 80
ActiveSense Rodent Sensor(s)
Determined by Site
Optional
Snap Foot
Based upon Device (Trap) Requirements
Optional
Range Extender
1
Range Extender Power Supply
Required for Range Extender
1
Range Extender Antenna
Required for Range Extender
Note: Only ActiveSense components and peripherals should be used for site installations. Any
unapproved peripherals installed will invalidate the component warranty.
Section 3.3: ActiveSense Hub Installation
Step 1: Unbox the new ActiveSense Hub. Position the Hub in the stand and orient the two antennas
vertically.
vertically.
Warning:
Take care not to force the antennas in this upright position, as it may cause damage to
the antennas and/or the Hub.
Step 2: Determine Hub placement. Suggested best practices:
●
Locate indoors (hub device is not weather-resistant)
●
Locate as close as possible to the center of the building (to achieve maximum coverage)
●
Locate as high as possible (2
nd
, 3
rd
, 4
th
floor, etc. in a multi-story building)
●
Antennas oriented up
●
Must be able to connect to the Verizon cellular network
Step 3: Plug the power adapter into an electrical outlet and plug the other end into the back of the hub
device. After a few seconds, the Hub should look similar to this: