Sichuan Changhong Electronic Component Co. Ltd. M603USA1 Manuel D’Utilisation

                                                                                                                                                                       

      WIFI-M603USA1 

                                                                                                                                                                       

                                                                                                                                                                       

                                                                                                                                                                       

                                                                                                                                                                       

四川长虹电子部品有限公司

 

                                                                              

Sichuan Changhong Electronic Component Co., Ltd.                                                              page 

 

 

This device complies with Part 15 of the FCC rules. Operation is subject to the 

following two conditions: 1) this device may not cause harmful interference, and 2) 

this device must accept any interference received, including interference that may 

cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no guarantee that 

interference will not occur in particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement

This modular complies with FCC RF radiation exposure limits set forth for an 

uncontrolled environment. This transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter.

Note 1: Compliance of this device in all final host configurations is the responsibility of the 

Grantee. OEM integrators are responsible to satisfy RF exposure requirements. SAR evaluation is 

valid for mobile applications. 
Note 2: Any modifications made to the module will void the Grant of Certification, this module is 

limited to OEM installation only and must not be sold to end-users, end-user has no manual 

instructions to remove or install the device, only software or operating procedure shall be placed 

in the end-user operating manual of final products. 
Note 3: The device must not transmit simultaneously with any other antenna or transmitter. 
Note 4: To ensure compliance with all non-transmitter functions the host manufacturer is 

responsible for ensuring compliance with the module(s) installed and fully operational. For 

example, if a host was previously authorized as an unintentional radiator under the Declaration 

of Conformity procedure without a transmitter certified module and a module is added, the host 

manufacturer is responsible for ensuring that the after the module is installed and operational 

the host continues to be compliant with the Part 15B unintentional radiator requirements. Since 

this may depend on the details of how the module is integrated with the host, Sichuan 

Changhong Electronic Component Co., Ltd. shall provide guidance to the host manufacturer for 

compliance with the Part 15B requirements.
Note 5: FCC ID label on the final system must be labeled with “Contains FCC ID: 2AC49-M603USA1” 
The transmitter module must be installed and used in strict accordance with the manufacturer's 

instructions as described in the user documentation that comes with the host product. Sichuan 

Changhong Electronic Component Co., Ltd. is responsible for the compliance of the module in all 

final hosts.