Skspruce Technologies Inc. WIA3200 Manuel D’Utilisation

 

Step 4      Enter the global mode using the following command: 

 (JadeOS) > enable 

Password: enable 

When you are in enable mode, the > prompt changes to a pound sign (#): 

 (JadeOS) # 

Step 5    Enter the configuration mode using the following command: 

  (JadeOS) # configure terminal 

When you are in the configuration mode, ‘config’ appears before the # prompt: 

  (JadeOS) (config) # 

Users can access JadeOS remotely using TELNET from a TCP/IP network.   
To access JadeOS via telnet you need to enable telnet sessions using telnet cli com-
mand.

 

To connect to the CLI using TELNET, complete the following steps: 
Step 1   Verify that your terminal emulation program or DOS shell interface (for 
example: SecureCRT) is configured as shown in figure 3-2:   

 

Figure 3-2 Telnet connection settings 

Step 2   Enter a valid username and password as prompt. 

This chapter will give a general introduction about the CLI commands.