Zenner Performance Meters Inc d.b.a. Zenner USA GM1 Manuel D’Utilisation
Stealth Reader MIU User’s Manual Rev 17A
Copyright 2017, Zenner USA
Page 3
Confidential
NOTICES
Patents
This product contains Stealth Reader Technologies that are licensed by the manufacturer and are protected
by US Patents including: 7782804, 7996534, 8126488, 8351409, 8428558 and 8428630. The furnishing of
this document and/or purchasing of the associated products does not give you any license to or ownership
of such patents.
by US Patents including: 7782804, 7996534, 8126488, 8351409, 8428558 and 8428630. The furnishing of
this document and/or purchasing of the associated products does not give you any license to or ownership
of such patents.
Copying
No part of this manual or associated hardware or software products may be reproduced in any form or by
any means including, without limitation, electronic or mechanical such as photocopying or recording, or by
any information storage and retrieval systems without the express written consent of Zenner USA.
Specifications are subject to change without notice.
any means including, without limitation, electronic or mechanical such as photocopying or recording, or by
any information storage and retrieval systems without the express written consent of Zenner USA.
Specifications are subject to change without notice.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference and (2) This device must accept any
interference including that which may cause undesired operation.
subject to the following two conditions: (1) This device may not cause
harmful interference and (2) This device must accept any
interference including that which may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning this equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This document is applicable to equipment with the following FCC Identifiers:
FCC ID: 2ACOA-GM1
Caution: Changes or modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
To comply with FCC RF exposure requirements, the device and the antenna for this device must be
installed to ensure a minimum separation distance of 20 cm or more from a person's body. Other
operating configurations should be avoided.
user’s authority to operate the equipment.
To comply with FCC RF exposure requirements, the device and the antenna for this device must be
installed to ensure a minimum separation distance of 20 cm or more from a person's body. Other
operating configurations should be avoided.