Enjoy Research Inc XBT40A Manuel D’Utilisation

PIN define： 

PIN Number   

PIN Number 

 

PIN 4 

VCC   

PIN 7 

RTS 

PIN 31 

GND   

PIN 20 

CTS 

PIN 23 

RX   

 

 

PIN 24

 

TX  

 

 

LABEL OF THE END PRODUCT: 

The final end product must be labeled in a visible area with the following " Contains 

TX FCC ID: 2ACORXBT40A ".   

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) This device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may 

cause undesired operation. 

   

IMPORTANT NOTE: 

This module is intended for OEM integrator. The OEM integrator is still responsible 

for the FCC compliance requirement of the end product, which integrates this module. 

Appropriate measurements (e.g. 15 B compliance) and if applicable additional 

equipment authorizations (e.g. Verification , Doc) of the host device to be addressed 

by the integrator/manufacturer. 

20cm minimum distance has to be able to be maintained between the antenna and the 

users for the host this module is integrated into. Under such configuration, the FCC 

radiation exposure limits set forth for an population/uncontrolled environment can be 

satisfied. 

Any changes or modifications not expressly approved by the manufacturer could void 

the user's authority to operate this equipment. 

 

This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules.    These limits are designed to 

provide reasonable protection against harmful interference in a residential installation.   

This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference 

to radio communications.    However, there is no guarantee that interference will not 

occur in a particular installation.    If this equipment does cause harmful interference 

to radio or television reception, which can be determined by turning the equipment off