jWIN JXM89 Manuel D’Utilisation

www.jWIN.com 

 

9 

1.  This unit has the built-in AM/FM antennas. Thus, an external FM wire antenna isn’t required to 

be installed on this unit to receive the FM radio. However, if you reside in the poor reception 
area and want to enhance the FM radio reception more, you might attach the pigtail wire 
antenna at the external FM antenna terminal located on the back of the unit.  

2.  To get better AM radio reception, be sure to place the unit horizontally and reposition it if there 

are noises on the AM station. 

 
Cleaning the Unit 
1. 

To prevent fire or shock hazard, disconnect your unit from the AC power source when 
cleaning. 

2. 

The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, 
Use caution when cleaning and wiping the plastic parts. 

3. 

If the cabinets become dusty, wipe them with a soft dry dust cloth. Do not use any wax or 
polish sprays on the cabinets. 

4. 

If the front panel becomes dirty or smudged with fingerprints, it may be cleaned with a soft 
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or 
polishes as these will damage the finish of your unit. 

 
Caution: never allow any water or other liquids to get inside the unit while cleaning. 

 

 

Cleaning the Disc 
1. 

Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to 
contact with the shiny, unprinted side of the disc. 

2. 

Do not attach adhesive tape, stickers etc., to the disc label. 

3. 

Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive 
cleaners to clean the disc. If necessary, use a CD cleaning kit. 

4. 

If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged 
(scratched). 

5. 

When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the 
disc. Never wipe in circular motions. 

6. 

To remove a disc from its storage case, press down on the centre of the case and lift the 
disc outs, holding it carefully by the edges. 

7. 

Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft 
cloth. Unlike conventional records. compact disc have no groove to collect dust and 
microscopic debris, so gently wiping with a soft cloth should remove most particles. 

 
Note: Do not use solvents such as benzine petrol, thinner, commercially available cleaners or 
anti-static spray intended for analogue discs.

 

 
 

www.jWIN.com 

 

2

 
IMPORTANT SAFETY INSTRUCTIONS – CONTINUED 
11.  SERVICING - The user should not attempt to service the appliance beyond that described 

in the user's operating instructions. All other servicing should be referred to qualified 
service professional. 

12.  BATTERY USAGE – To prevent battery leakage, which may result in bodily injury, 

property damage or damage to the unit, follow these instructions: 

a. 

Install all batteries correctly according to the polarity (+ -) as marked on the unit. 

b. 

Do not mix old and new batteries, carbon and alkaline, etc. 

c. 

Remove batteries from the unit when the device will not be used for an 
extended period of time. 

13.  LEAD AND MERCURY - This product may contain lead and/or mercury. Disposal of these 

materials may be regulated by your local authorities due to environmental considerations. 
For more detailed disposal or recycling information, please contact your local authorities or 
the EIA (Electronic Industries Alliance) – http://www.eiae.org 

 
IMPORTANT NOTES 
1. 

Do not attempt to clean the unit with chemical solvents as this might damage the finish. 
Use a clean, dry cloth. 

2. 

Keep this manual in a safe place for future reference. 

 
 
You can help to protect the environment! 
Please remember to respect the local regulations: Hand in the non-working 
electrical equipment to an appropriate waste disposal center. 
 
 
TO A USER IN USA 
This equipment has been tested and found to comply with the limits for a Radio Receiver, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures: 
- 

Reorient or relocate the receiving antenna. 

- 

Increase the separation between the equipment and receiver. 

- 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 

- 

If necessary, consult the dealer or an experienced radio / TV technician for additional 
suggestions.