Shenzhen Huadoo Bright Group Limited H2 Manuel D’Utilisation

 

 

 

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types mobile phone (FCC ID: 

2ACXS-H2) has also been tested against this SAR limit. The highest reported SAR values for head, body-worn 

accessory, product specific (wireless router), and simultaneous transmission conditions are 0.18W/kg, 0.48W/kg , 

0.62W/kg, and 0.67W/kg respectively. This device was tested for typical body-worn operations with the back of 

the handset kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use 

accessories that maintain a 10mm separation distance between the user's body and the back of the handset. The 

use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use 

of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and 

should be avoided. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

 

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 

measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

 

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment.