Vubiq Networks Inc. V10G-L Manuel D’Utilisation
67
Vubiq HaulPass V10g User Manual
© 2018 Vubiq Networks, Inc. All Rights Reserved
10.3 rf tx (RF Tx Module Setting/Status)
freq (Tx frequency setting (GHz))
The rf tx freq command will tell the user which frequency the Vubiq HaulPass V10g terminal is transmitting at. The
receiver and transmitter frequencies must be different and the terminal at the other end of the link must reverse
those frequencies in order to have a link between them. Transmitting at 57.78 GHz makes the terminal a
receiver and transmitter frequencies must be different and the terminal at the other end of the link must reverse
those frequencies in order to have a link between them. Transmitting at 57.78 GHz makes the terminal a
“Low” and
transmitting at 64.26 GHz makes the terminal a “High”.
CLI example:
# rf rx freq
64.26
# rf tx freq
57.78
#
64.26
# rf tx freq
57.78
#
Web GUI example:
MIB: vubiqRfTxFreq
OID: .1.3.6.1.4.1.46330.2.2.1.1.0 (Integer)
if (Tx IF atten setting)
The Transmitter IF attenuation setting can be discovered through the RF TX IF Atten setting. The value is in dB.
CLI example:
# rf tx if atten ?
<word> Atten value in dB. One of { 0 | 1.3 | 2.7 | 4.0 | 5.3 | 6.7 | 8.0
| 9.3 | 10.7 | 12.0 | 13.3 | 14.7 | 16.0 | 17.3 | 18.7 | 20.0 }
<cr>
# rf tx if atten 4.0
# rf tx if atten
4.0
#
<word> Atten value in dB. One of { 0 | 1.3 | 2.7 | 4.0 | 5.3 | 6.7 | 8.0
| 9.3 | 10.7 | 12.0 | 13.3 | 14.7 | 16.0 | 17.3 | 18.7 | 20.0 }
<cr>
# rf tx if atten 4.0
# rf tx if atten
4.0
#