TE Connectivity Germany GmbH ARISO Manuel D’Utilisation
Datasheet
ARISO M30 GPIO
DS 116-19004 Rev. 13
07
th
of December 2016
TE Connectivity Ltd.
*
Trademark
| Indicates change
This specification is a controlled document and subject to change.
2016 TE Connectivity Germany GmbH, a TE Connectivity Ltd. company.
All rights reserved.
Page 22 of 22
NOTES AND STATEMENTS – FCC ID: 2ADK7-ARISO // ISED: 12496A-ARISO
Intended use: Coupler to transfer 12W power and data (digital GPIO link), integrated in a control system.
This device complies with Industry Canada licence-exempt RSS standard(s) and part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
The interference potential of the device is low as it is a low frequency device with a near field antenna, designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment and accordingly tested.
If this equipment does cause harmful interference, which can be determined by turning the equipment off and on by
disconnecting the couplers from the power and signal source, the user is encouraged to try to correct the interference
by one or more of the following measures:
1. Increase the separation between this equipment and the disturbed one
2. Consult the dealer or an experienced technician for help
No maintenance of the device is needed, once installed and used in accordance with the instruction manual.
Notes et déclarations:
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux condition suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
Nummer der „Benannten Stelle“ (NBnr): 0344