Zeeva International Limited VZ400GL Manuel D’Utilisation

3

4

6

5

7

8

1

2

Thank you for purchasing the “Vivitar Bluetooth Neck Buds”.
You can connect this headset wirelessly to most audio devices in order to listen to music. 
Please read this manual carefully FIRST in order to get the most of your device.

Note: Your Bluetooth headset can be used as an audio accessory for iPad®, iPhone®, 
tablets and most audio device that has Hands Free Bluetooth Profile.

1. Vivitar Bluetooth Neck Buds
2. USB Charging Cable
3. User Manual

- Speaker Driver: 10mm
- Frequency Response: 20Hz-20 KHz
- Sensitivity: 100dB+/-3dB
- Impedance: 16 +/- 3 Ohms 
- Bluetooth Version: 4.1
- Charging Time:  2 hours
- Playing Time:  1.5 hours

User’s Guide

To extend the life of your device, all of the following operating and safety instructions
should be read, adhered to and followed before the unit is operated.
For your Safety:
1. Please carefully read this User Guide before operating the unit.
2. Take a few moments to review the User Guide while using your unit for the first time.
3. Do not place or store the unit in areas where it can be exposed to water or other liquids.
Care should be taken so that water or other liquids cannot be spilled onto the unit.
4. Protect the unit from vibration, or shock. Always keep it on a flat dry surface.
5. Unplug the unit when it is not in use for extended periods.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) This device must accept any interference received, 

including interference that may cause undesired operation.

Warning:  Changes or modifications to this unit not expressly approved by the party responsible for compliance could void 

the user’s authority to operate the equipment.

NOTE:  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 

FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation.  

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged 

to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

  

Bluetooth Device Pairing
Before using the headset for the first time, you must pair it with a Bluetooth-enabled device.
1. When pairing, keep the distance between the mobile phone and the headphones
     within 32.8 feet.
2. Long press the Multi Function button, the headset has entered pairing mode when the
     red and blue lights alternately blink.
3. Search your Bluetooth device on your phone by following your phone’s instruction. 
    Refer to your phone’s user manual for more information. 
4. After a few seconds the phone will list the “VZ400GL WL Earbuds” as a discovered device. 
    Select it for Bluetooth pairing.
5. Once the devices are paired, you will hear “Connected” and the LED indicator light will
     be flashing blue light.
6. If the mobile phone prompts to enter the pairing password, please enter “0000" and confirm.

ITEM # VZ400GL

In the U.S.

Sakar International

Attention: Service Department

195 Carter Drive

Edison, NJ 08817

You may also visit www.sakar.com for futher assistance if

necessary or call our technical support department toll free at

1877 397 8200 in the US, or 0-800-917-4831 in the UK.

In the U.K.

Sakar UK

2D Siskin

Parkway East

CV3 4SU,UK

FCC ID:  2ADM5-VZ400GL 

Battery Charging
Before use, make sure battery is fully charged.
1. Find the micro USB slot located on the headphones in-line control
2. Plug Micro USB (small) end into the slot, plug the standard USB (large) end into a 
    charging port or computer.
3. While charging the red LED light is constantly on. When fully charge the blue LED is on.
    When charging is completed, unplug both ends. The headphones are ready for use.

Low Battery Alert
1. A low battery alert sound will play once every 30 seconds. 
2. If the battery is not charged, the headset will turn off once the battery runs out.

Power On/Off
Long press the Multi Function button for power on, long press the power button again to off.

1. Please clean the unit with a soft dry cloth.
2. Do not press the unit with undue pressure or place any objects on it.
3. Discontinue use if damaged.

Answering / Ending a Call
Press the power button to answer the incoming call, and press the power button again
to end the call.

Rejecting a Call
Press the power button for 2 seconds when the handset rings.

Redial Last Number 
Double press the power button for redialing the last number that you just called.

Music Pause
Press the button to pause playing, and press the again to resume playback.

Volume Control
1. Volume Up Button
    - Long press: Increase volume 
    - Short press: Play next track

2. Volume Down Button
    - Long press: Decrease volume 
    - Short press: Play previous track

1 . Device Pairing LED
2 . Volume up / Next Song
3 . Volume down / Last Song  
4 . Multi Function

5 . Microphone
6 . USB Charging Port
7 . Magnetic Holder
8 . Earphones