SHENZHEN AVWOO TECHNOLOGY CO. LTD A081 Manuel D’Utilisation

Craig Electronics Inc. warrants this product to be free from 

manufacturing defects in material and workmanship under 

normal use for a period of 180 days from date of purchase. 

If service is required, please return the product to the store 

where it was purchased for exchange; or, pack the unit in 

the original packing material with all accessories if applicable, 

a copy of your sales receipt and a Cashier’s check or 

Money Order for $7 (to cover shipping and handling costs) 

payable to Craig Electronics Inc. For consumers in Canada, 

please make sure that the cashier check or money order is 

redeemable through a U.S. bank. Ship your product freight 

pre-paid. Your unit will be repaired, replaced or if the unit 

can not be repaired or replaced, a refund will be forwarded 

to you within four weeks of receipt of your unit. Please ship 

your unit to:

Craig Electronics Inc.

1160 NW 163 Drive

Miami, Fl 33169

This warranty is void if the product has been: a) Used in a 

commercial application or rental. b) Damaged through 

misuse, negligence, or abuse. c) Modified or repaired by 

anyone other than an authorized Craig Electronics Inc. 

service center. d) Damaged because it is improperly 

connected to any other equipment.

Note: This warranty does not cover: a) Ordinary adjustments 

as outlined in the Owner’s Manual which can be performed 

by the customer. b) Damage to equipment not properly 

connected to the product. c) Any cost incurred in shipping 

the product for repair. d) Damage to the product not used in 

the USA.
This warranty is not transferable and only applies to the 

original purchase. Any implied warranties, including the 

warranty of merchantability, are limited in duration to the 

period of this expressed warranty and no warranty whether 

expressed or implied shall apply to the product thereafter.
Under no circumstance shall Craig Electronics Inc. be liable 

for any loss or consequential damage arising out of the use 

of this product. This warranty gives specific legal rights. 

However, you may have other rights which may vary from 

state to state. Some states do not allow limitations on 

implied warranties or exclusion of consequential damage. 

Therefore, these restrictions may not apply to you.
This product has been manufactured by and is sold under 

the responsibility of Craig Electronics Inc., and Craig 

Electronics Inc. is the warrantor in relation to this product. 

MAGNAVOX and SMART. VERY SMART are registered 

trademarks of Koninklijke Philips N.V. and are used under 

license from Koninklijke Philips N.V.

To Obtain Service on your Product

email:service@craigelectronics.com

Printed in China 

MMA3650_WC_E0FK1_B0WU

This equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to Part 15 of 

the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interfer-

ence to radio or television reception, which can be 

determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more 

of the following measures:
 ● Reorient or relocate the receiving antenna.  

 ● Increase the separation between the equipment and 

     receiver.   

 ● Connect the equipment into an outlet on a circuit 

     different from that to which the receiver is connected.  

 ● Consult the dealer or an experienced radio/TV 

     technician for help.

1. This device complies with Part 15 of the FCC Rules.

    Operation is subject to the following two conditions:

    (1) This device may not cause harmful interference, and

    (2) This device must accept any interference received, 

          including interference that may cause undesired 

          operation.

2. Changes or modifications not expressly approved by the 

    party responsible for compliance could void the user's 

    authority to operate the equipment.

To assure continued compliance, follow the attached

installation instructions and use only shielded cables

when connecting to other devices. Modifications not

authorized by the manufacturer may void user`s authority

to operate this device.
The  Bluetooth   word mark and logos are registered 

trademarks owned by Bluetooth SIG, Inc. and any use of 

such marks by Craig is under license. Other trademarks 

and trade names are those of their respective oweners.”
                                                               

1

MODEL: MMA3650

● When the external BT Device searches for the unit, our 

   model number “MMA3650” will appear on the display of 

   external BT Device.

● If while pairing you are asked for a code please try "0000" 

   or "1234".

1. Power on the external BT Device and enter to BT mode.

2. Press and hold the      Button on the unit to power on the 

    unit. The Blue Indicator on the unit will illuminate and blink. 

3. Wait a few seconds until the unit auto pairs to the external 

    BT Device. (The Blue Indicator will stop blinking).

4. If pairing is complete you may now play music and/or 

    singing with your external BT Device.

To listen and sing with the music from the external Audio 

Player such like MP3 Player, Discman…etc.

1. In power on mode, connect the 3.5mm stereo plug from 

    the supplied Audio (In) Connection Cable to the AUX  

    Out/Line Out /Phone Jack on the external Audio Player.

2. Connect the Micro USB Plug from the Connection Cable  

    to the Micro USB Jack on the unit as illustrated below. 

    The BT Function will be automatically cut off and the Blue 

    Indicator will start blinking.

                                             To AUX Out/Line Out/

         

                                      Phone Jack on the 

        

                                       external Audio Player

3. Play the music on the connected Player as usual. (Adjust 

    the music level by the Volume Controls on the connected 

    Audio Player as usual.) 

4. Sing or speak to the Microphone. Then:

    A. Slide the VOL (Microphone Volume) Control Knob on 

        the unit to adjust the volume level of the Microphone as 

        desired.

    B. Slide the ECH (Microphone Echo Effect) Control Knob 

        to adjust the echo effect of the Microphone as desired.

           

 

To listen to music and sing through the external Audio Power 

Amplifier:

1. Power on the unit and enter to BT playback mode as 

    previously instructed.

2. Connect one end of the supplied Audio (Out) Connection 

    Cable to the AUX In/Line In Jack on the external Audio 

    Power Amplifier as illustrated below:

4

                                              To AUX Out/Line Out/

         

                                      Phone Jack on the 

        

                                       external Audio Player

3. Connect the other end of the  Connection Cable to the 

    AUX (Out) Jack on the unit as illustrated below. The unit 

    will automatically switch to AUX (Out) mode. (Note: 

    Sound from the speaker will automatically cut off).

                                              To AUX Out/Line Out/

         

                                      Phone Jack on the 

        

                                       external Audio Player

4. To resume to normal playback mode, unplug the cable 

    from the AUX (Out) Jack.

The unit has a built-in USB Charger. Use it to charge the

external USB Device as follows:

1. Make sure the unit is in power on mode.

2. Connect the full size USB Plug from the charging cable

    (Not included) from external USB Device to the USB

    Port.

3. Charging will auto start. Monitoring the charging status

    by the charging indicators on the external USB Device

    as usual.

4. When finished charging, disconnect the external USB

    Device from the USB Port.

            

                                      To charging port of the

                                      external USB Device

A. The capacity of the built-in battery is 1200 mAH 

    (4.44WH). Never use it to recharge the external USB 

    Device their battery is bigger than it.

B. Before charging the external USB Device, check the

    power of the built-in battery. If the power of the battery

    is too low, it cannot use to charge the external USB

    Device.

C. The Charger has a built-in overload/overheats protector.

    If the output of the Charger is overload, the unit will shut 

    off automatically. To reset the unit:

    ● Unplug the external USB Device from the USB Port.

    ● Connect the unit to the Computer or USB Charger to 

       recharge the unit as usual then the unit will be reset.

5

                                          1. USB Port (For charging the 

                                              external USB Device only)                                                                                              

                                                                                      

                                          2. LED Indicators                                                                                                                                                                                                                   

                                          3.      Power On/Off Button 

                                          4. ECH (Microphone Echo Effect) 

                                              Control Knob

                                          5. VOL (Microphone Volume) 

                                              Control Knob

                                          6. Micro USB Port (For recharging                  

                                              and AUX In)

                                          7. AUX Out Jack

                                          8. Microphone

                                          9. Speaker

                                                                             

The unit has a built-in Li-ion rechargeable battery, charge it 

before first time use or when it is drained as follows:

1. Connect the small plug from the supplied USB Connection 

    Cable to the Micro USB Port on the unit.

2. Connect the full sized USB plug from the supplied USB 

    Connection Cable to the USB Port on the Personal 

    Computer or USB Charger (Computer and USB Charger 

    not included) as illustrated below:

                                          To Computer or any USB Charger  

3. When charging, the Red Charging Indicator on the unit 

    will illuminate. When finished charging, it will turn off.

1. When charging, you can play music or sing as usual.

2. Your battery will last longer if you following these simple 

    guidelines for caring and storing.

    A. Before first time use, charge the unit approximately 4 

        hours until the unit is fully charged.

    B. Charge and store the unit within the temperature range 

        of 5°C - 35°C (40°F - 95°F).

    C. Do not overcharge (longer than 24 hours). Excessive 

        charging or running the unit until battery fully drains will 

        damage battery. Battery life will be extended if you keep 

        the battery fully charged.

2

   D. Battery life naturally shortens slowly over time.

   E. The rechargeable battery incorporated in this product 

        is not user replaceable.

To reduce the risk of fire or burns:                               

Do not disassemble, crush, puncture, or short external 

connectors contacts.

Use only with specified charger and player.

Do not dispose of in fire or water.

Do not dispose to high temperatuer above 60°C (140°F).

Store between 0°C (32°F) and 60°C (140°F).

Keep away from childen.

See operating instructions of this battery or product.

Batteries should be recycled or disposed of as per State and 

Local guidelines.   

For first time use or re-pairing the unit to a new BT Device, 

follow instructions below:

1. Press and hold the     Button to power on the unit. The 

    Blue Indicator on the unit will illuminate and blink. 

2. Power on the external BT Device and enter to BT 

    searching mode. Start pairing following the on screen 

    instructions from the external BT Device. When paired, 

    the Blue Indicator will stop blinking.

3. If pairing is complete you may now play music with your 

    external BT Device.

4. During playback:

    ● Use the Volume Controls on the paired BT Device to 

       adjust volume level as desired.

    ● Using the Pause; Skip Controls on the paired BT 

       Device to pause, skip tracks as desired.

    ● Sing or speak to the Microphone. Then: 

       A. Slide the VOL (Microphone Volume) Control Knob 

           on the unit to adjust the volume level of the 

           Microphone as desired.

       B. Slide the ECH (Microphone Echo Effect) Control  

           Knob to adjust the echo effect of the Microphone as 

           desired.

           Note: If feedback noise (high audio frequency noise) 

           is sounding from the speaker. Reduce the music 

           volume level or reduce the microphone volume level 

           by sliding the VOL (Microphone Volume) Control 

           Knob downward.

5. To shut off the unit, press and hold the     Button on the 

    unit until the Blue Indicator is turned off. 

3

 

Recharge the battery as page 2

Increase the volume by the 

volume controls on the paired 

/connected BT device

Unplug the Audio Connection 

Cable from the AUX (Out) Jack

Reduce the volume level by the 

volume controls on the paired 

/connected BT device

Pair the external BT Device to 

the unit as page 3

Place the external BT device 

close to the unit

Built-in battery consumed

Volume of the unit was set 

to minimum position

Audio Connection Cable 

was inserted into the AUX 

(Out) Jack

Volume level too high

The external BT Device 

had NOT paired to the unit

The external BT device 

too far from the unit

Can’t power on

No sound or 

sound weak

Sound 

distortion

BT not 

functioning

Check the following before requesting service:

1 x Owner’s Manual 

1 x Audio (In) Connection Cable with 3.5mm Plugs

1 x Audio (Out) Connection Cable with 3.5mm and Micro 

      USB Plugs

1 x USB Connection Cable with Full size and Micro USB 

      Plugs

6

Power Source

Impedance of the Speaker

Audio Power

BT Version

BT Operation Distance

Out put from the Built-in 

Charger                                   

Built-in DC        3.7V, 1200 mAH (4.44WH) rechargeable 

Li-ion Battery; Recharge by DC         5V through Micro 

USB Port

3 W; 4 ohm

1.5 W (RMS)

4.1

≧

 32 Feet in open area

DC       5V, 1A Max.

MODEL: MMA3650

PLEASE READ BEFORE OPERATING THIS EQUIPMENT.

Li-ion Battery Must Be

DisposedOf Properly

Portable karaoke microphone and speaker

Model:MMA3650, A081