MAXWEST INTERNATIONAL LIMITED. NITRO55R Manuel D’Utilisation
home screen
swipe up to open
Drawer
and location
Application G
and then
enter the proper
Android System
Transfer
Files
Disconnect device from PC
>>
internet >> Select
>> Select
Preference >> Select Advanced
>>
Changing Sound levels and change your ring tones.
8.1
TM
Oreo
TM
(Go edition)
8
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
R
R
H
8 10 AM
H
H
8 10 AM
H
H
8 10 AM
H
6
5
4
1
1
7
3
2
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment. This device complies with part 15 of the FCC Rules
and Industry Canada license-exempt RSS standard (s). Operation
is subject to the following two conditions:
responsible for compliance could void the user's authority to operate
the equipment. This device complies with part 15 of the FCC Rules
and Industry Canada license-exempt RSS standard (s). Operation
is subject to the following two conditions:
this device may not cause interference
this device must accept any interference, including interference
that may cause undesired operation of the device.
that may cause undesired operation of the device.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet an a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet an a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
S A R t e s t s a r e c o n d u c t e d u s i n g s t a n d a r d o p e r a t i n g p o s i t i o n s
accepted by the FCC/ISEDC with the device transmitting at its
highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual
SAR level of the device while operating can be well below the
maximum value, in general, the closer you are to a wireless base
station antenna, the lower the power output.
accepted by the FCC/ISEDC with the device transmitting at its
highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual
SAR level of the device while operating can be well below the
maximum value, in general, the closer you are to a wireless base
station antenna, the lower the power output.
Before a new device is a available for sale to the public, it must be
tested and certified to the FCC/ISEDC that it does not exceed the
exposure limit established by the FCC/ISEDC, Tests for each device
are performed in positions and locations as required by the FCC/
ISEDC.
tested and certified to the FCC/ISEDC that it does not exceed the
exposure limit established by the FCC/ISEDC, Tests for each device
are performed in positions and locations as required by the FCC/
ISEDC.
For body worn operation, this device has been tested and meets
the FCC/ISEDC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that
the FCC/ISEDC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that
contains no metal and that positions the handset a minimum of
mm from the body.
Non-compliance with the above restrictions may result in violation
of RF exposure guidelines.
of RF exposure guidelines.
N
N
10