Cisco SF200E-24 SF200E-24-EU Fiche De Données
Codes de produits
SF200E-24-EU
© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 5 of 8
Data Sheet
Feature
SF200E-24
SF200E-24P
SF200E-48
SF200E-48P
IPv6
IPv6
IPv6 host mode
IPv6 over Ethernet
Dual IPv6/IPv4 stack
IPv6 neighbor and router discovery (ND)
IPv6 stateless address auto-configuration
DHCP v6 Client
Path maximum transmission unit (MTU) discovery
Duplicate address detection (DAD)
Internet Control Message Protocol (ICMP) version 6
IPv6 QoS
Prioritize IPv6 packets in hardware
Multicast Listener Discovery (MLD)
snooping
snooping
Deliver IPv6 multicast packets only to the required receivers
IPv6 applications
Web, ping, Trivial File Transfer Protocol (TFTP), DNS client, TELNET, SSH, Bonjour
IPv6 RFCs supported
RFC 2463: ICMP version 6
RFC 3513: IPv6 address architecture
RFC 4291: IPv6 addressing architecture
RFC 2460: IPv6 specification
RFC 2461: Neighbor discovery for IPv6
RFC 2462: IPv6 stateless address auto-configuration
RFC 1981: Path maximum transmission unit (MTU) discovery
Management
Web user interface
Built-in switch configuration utility for easy browser-based device configuration (HTTP). Supports
configuration, system dashboard, system maintenance, and monitoring
configuration, system dashboard, system maintenance, and monitoring
SNMP
SNMP versions 1, 2c, and 3 with support for traps, and SNMP version 3 user-based security
model (USM)
model (USM)
Remote Monitoring (RMON)
Embedded RMON software agent supports 4 RMON groups (history, statistics, alarms, and
events) for enhanced traffic management, monitoring, and analysis
events) for enhanced traffic management, monitoring, and analysis
IPv4 and IPv6 dual stack
Coexistence of both protocol stacks to ease migration
Firmware upgrade
Web browser upgrade (HTTP) and TFTP
Port mirroring
Traffic on a port can be mirrored to another port for analysis with a network analyzer or RMON
probe. Up to 4 source ports can be mirrored to one destination port. A single session is
supported.
probe. Up to 4 source ports can be mirrored to one destination port. A single session is
supported.
VLAN mirroring
Traffic from a VLAN can be mirrored to a port for analysis with a network analyzer or RMON
probe. Up to 4 source VLANs can be mirrored to one destination port. A single session is
supported.
probe. Up to 4 source VLANs can be mirrored to one destination port. A single session is
supported.
DHCP (Options 66 and 67)
Dynamic Host Configuration Protocol (DHCP) options facilitate tighter control from a central point
(DHCP server) to obtain IP address, auto-configuration (with configuration file download)
(DHCP server) to obtain IP address, auto-configuration (with configuration file download)
Textview CLI
Scriptable command-line interface
Localization
Localization of GUI and documentation into multiple languages
Other management
HTTP, RADIUS, port mirroring, TFTP upgrade, DHCP client, BOOTP, SNTP, ping, syslog, SSH;
cable diagnostics; Telnet client (SSH secure support)
cable diagnostics; Telnet client (SSH secure support)
Power Efficiency
Energy Detect
Automatically turns off power on RJ-45 port when the switch detects a link down
Active mode is resumed without loss of any packets when the switch detects the link is back up
General
MAC table
Up to 8192 MAC addresses
Discovery
Link Layer Discovery Protocol
(LLDP) (802.1ab) with LLDP-MED
extensions
(LLDP) (802.1ab) with LLDP-MED
extensions
LLDP allows the switch to advertise its identification, configuration, and capabilities to
neighboring devices, which store the data in an MIB. LLDP-MED is an enhancement to LLDP that
adds the extensions needed for IP phones.
neighboring devices, which store the data in an MIB. LLDP-MED is an enhancement to LLDP that
adds the extensions needed for IP phones.