Appareo Systems LLC 000034 Manuel D’Utilisation
Installation Manual
Rev: 1.2
Last Revised: 3/22/16
Document Number: 600840-000038
Page 10 of 11
5.
REGULATORY INFORMATION
5.1. FEDERAL COMMUNICATIONS COMMISSION NOTIFICATION TO
USER
Harvey, Gateway High Spec, GW 400, GW 410, and GW 411
These devices comply with Part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions: (1) These devices may not cause harmful
interference, and (2) these devices must accept any interference received, including
interference that may cause undesired operation.
These devices must be operated as supplied by Appareo Systems LLC. Any changes or
modifications made to these devices without the express written approval of Appareo Systems
LLC may void the user’s authority to operate these devices.
This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, no
guarantee shall be made that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
5.2. INDUSTRY CANADA NOTIFICATIONS TO USER
Harvey, Gateway High Spec, GW 400, GW 410, and GW 411
English
These devices complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
These devices complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.