Beijing Spirit Technology Development Co. Ltd SP-L51BTDM Manuel D’Utilisation
6
(Refer to<L51 Printer Command ProgramManual >).
● Power Supply: 7.4VDC/2300mAh rechargeable polymer lithium battery.
● Power Alarm: when the battery is low, the battery indicator on LCD blinks
● Battery Charging: quick charging, it will be charged full about 4 hours;
● Auto Sleep: printer will auto sleep when it have not received printing data or key
operation in 5 seconds, press FEED button/MODE button/Power switch or printer
receive any printing data in auto-sleep period will wake up the printer.
● Battery Duration: under25% printing density, at least 200 meters, the standby time is
over 6 days. These parameters are just for reference; long term usage will cause the
capacity decline, and cannot ensure the time of printing.
● Power Supply: 7.4VDC/2300mAh rechargeable polymer lithium battery.
● Power Alarm: when the battery is low, the battery indicator on LCD blinks
● Battery Charging: quick charging, it will be charged full about 4 hours;
● Auto Sleep: printer will auto sleep when it have not received printing data or key
operation in 5 seconds, press FEED button/MODE button/Power switch or printer
receive any printing data in auto-sleep period will wake up the printer.
● Battery Duration: under25% printing density, at least 200 meters, the standby time is
over 6 days. These parameters are just for reference; long term usage will cause the
capacity decline, and cannot ensure the time of printing.
Chapter 3 Operation Method
3.1Using Preparation
3.1.1 Battery Installation
1. Put the battery into the battery slot from the side with pins and press the other
side into case. (as below Pic.)
1. Put the battery into the battery slot from the side with pins and press the other
side into case. (as below Pic.)
3.1.2 Paper Roll Installation
1. Press the cover open button. (Pic.1)
2. Push the auto paper roll installation from the middle to the two ends (Pic2), put a
1. Press the cover open button. (Pic.1)
2. Push the auto paper roll installation from the middle to the two ends (Pic2), put a
new paper roll into the installation, and please mind the direction of the paper roll.
(Pic.3&Pic4)
(Pic.3&Pic4)
3. Pull out a part of paper and put the end of the paper in the middle of the paper out
orifice.
4. Shut down paper case cover and cut off the redundant paper
5. Repeat Step 3~4.
5. Repeat Step 3~4.