XMT Lab. Inc. GS1 Manuel D’Utilisation
5
Turn on power at circuit breaker.
Click the Base Switch to see if it works!
Now you can link it to the Gecko Switch!
Click the Base Switch to see if it works!
Now you can link it to the Gecko Switch!
HINT
Remember the Base Switch and Gecko Switch
is compatible with dimmable light bulbs.
Remember the Base Switch and Gecko Switch
is compatible with dimmable light bulbs.
ON
OFF
ON
OFF
ON
OFF
5
Turning ON power
Technical Assistance
If you have any questions about the installation or operation of this product, please contact us at:
help@xmtlab.com
www.geckoswitch.com
FCC
The device is approved by the FCC and it complies with Part 15 of the FCC rules. Its operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired operation.
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired operation.
WARNING
Changes or modifications to this unit not expressly approved by the party responsible of
compliance could void the user’s authority to operate the equipment.
Symptom
Cannot turn on/off the light
Light flicks or on/off
automatically
automatically
Possible Cause
Wiring error.
Burnt out light bulb.
Check circuit breaker is turned back on.
Burnt out light bulb.
Check circuit breaker is turned back on.
Using the dimmer function on a light bulb that is not dimmable.
Light bulb is less than minimal load required by the base switch.
Note that light bulb must be greater than 5 watts.
Light bulb is less than minimal load required by the base switch.
Note that light bulb must be greater than 5 watts.
Troubleshooting