The Watt Stopper Inc. d/b/a Qmotion DR20-908 Manuel D’Utilisation
8
Z-Wave Operating Notes
TAP COMMAND MODES
1. Tap 2 times within 800ms to enter command mode
2. Shade responds to signal command mode entry (Jog**)
3. Shade will time-out after 5 seconds of inactivity and perform command failure response (Jog**)
4. Once Shade enters command mode, perform additional Taps to send commands
A. Add/Remove shade —1 additional
B. Calibrate — 2 additional
C. Disable/Enable Wand — 3 additional
D. Battery Change Mode — 4 additional
E. Z-Wave Reset — 6 additional
F. Factory Reset — 8 additional
** Shade will perform command after a 5 second time-out from last Tap
OPEN/CLOSE SHADE FULLY WITH CONTROLLER
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Select On/Off to Open/Close respectively
OPEN/CLOSE SHADE FULLY MANUALLY
1. Tap once to open/close shade fully
SHADE INTERMEDIATE POSITIONS
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Use dimming or fixed intermediate position buttons
Z-WAVE RESET
1. Initiate Tap command mode, verify shade performs command mode entry action
2. Tap additional 6 times
3. Shade should perform command completion or failure action
4. After successful RESET, all shade calibration setting and Z-Wave setting are cleared, and the shade goes into low power
OPEN/CLOSE SHADE FULLY WITH CONTROLLER
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Select On/Off to Open/Close respectively
OPEN/CLOSE SHADE FULLY MANUALLY
1. Tap once to open/close shade fully
SHADE INTERMEDIATE POSITIONS
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Use dimming or fixed intermediate position buttons
Z-WAVE RESET
1. Initiate Tap command mode, verify shade performs command mode entry action
2. Tap additional 6 times
3. Shade should perform command completion or failure action
4. After successful RESET, all shade calibration setting and Z-Wave setting are cleared, and the shade goes into low power
__
mode.
Z-WAVE MODULE FIRMWARE UPDATE OVER-THE-AIR (OTA)
1. Supported on Z-Wave Plus controller for Z-Wave module firmware only