DUNOLLY GOLD WORLD PTY LTD V1-TX Manuel D’Utilisation
Operation instruction:
1. To make sure the unit work well, first press the TX on/off button to turn on the TX unit. The
1. To make sure the unit work well, first press the TX on/off button to turn on the TX unit. The
LED will flash fast.
2. Then turn on the RX by press the on/off button, the red LED light, few minutes late it turn to
blue LED light. The blue LED light means that the TX has linked with RX.
3. Audio signal send to the TX via micro usb D+,D- GND. The speaker of the RX will work.
4. If the RX red Led keep light, not change to blue LED, that means TX need pair with RX one
4. If the RX red Led keep light, not change to blue LED, that means TX need pair with RX one
time. To turn off the RX, then press the on/off button of the RX for 5s. The blue LED and Red
LED light alternately that means the RX is on the pairing mode, the TX will automatically pair
with RX. When the blue LED light that means the units can work well.
LED light alternately that means the RX is on the pairing mode, the TX will automatically pair
with RX. When the blue LED light that means the units can work well.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.