Byrne Electrical Specialists Inc. SA04850 Manuel D’Utilisation

Page de 6
User Manual - FCC Deliverables
 
Page 1 of 6 
 
by: C. Klem 
 
 
1.0  The SA04850 is a Qi module that is post-assembled with power input wires and LED indicators.  This 
post-assembly is then placed into a holder for each host housing. 
1.1  Host Housings and associated post-assemblies include: 
1.1.1 
Burele (SA06164) 
1.1.2 
Dean (SA06164) 
1.1.3 
Grommet (SA05887) 
1.1.4 
HQ/HQ2 (SA05460) 
1.2  Host Housings meet WPC 1.2 requirements for transmitter to receiver antenna spacing and 
alignment, so no other adjustments are necessary for proper operation once the post-assembly is 
placed into its host holder. 
 
2.0  The SA04850 must be wired to compatible power supply.  The power supply must be able to provide: 
 
Input voltage: 4.75V
DC
 to 5.50V
DC 
 
Input Current: 2.0A
MAX
, Inrush Current: 2.5A
MAX 
 
3.0  The SA04850 provides up to 5W of power to a Qi wireless power receiver.  It transmits power in the 
110KHz to 205KHz range. Output power field strength is 84.53 dB(uV/m). 
 
4.0  Compliance Statement (Part 15.19) 
4.1  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
1. This device may not cause harmful interference, and 
2. This device must accept any interference received, including interference that may cause undesired 
operation. 
 
5.0  Warning (Part 15.21) 
5.1  Changes or modifications not expressly approved by the party responsible for compliance could void the 
user’s authority to operate the equipment. 
 
6.0  Show compliance with the FCC Interference Statement (Part 15.105 (b)) 
6.1  The statement should be on label on end product, or if it will not be able to be seen by the end user, then it 
must appear in the user manual.  Include FCC-ID and IC-ID on label.   
 
FCC ID 2AJX5-SA04850        IC ID 22009-SA04850 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. 
 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the interference by one of the following 
measures: 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and receiver. 
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
• Consult the dealer or an experienced radio/TV technician for help