Shantou Dihua trading Co. Ltd 201805 Manuel D’Utilisation

Car run time: 6-10 minutes

Distance: 6-20 meters

Remote controller w/ antenna x1

n

Hold the release button down, and

slide the mini racer in the direction

of the large arrow.

Open the remote controller battery compartment, and insert

2 x 1.5V AA batteries, using the correct polarity. Replace the battery

compartment cover.

3.

 Press any button and

the signal indicator light

will illuminate to show that

the batteries are installed

correctly.

4.

 Insert and tighten the

antenna in the hole on

the remote controller.

Open the charger

cover, located on the

side of the remote

controller.

2.

 Insert the charging plug into the charging jack, located on the bottom of the

mini racer. The indicator light will illuminate when charging is in progress. After 1-2

minutes, the mini racer is fully charged and the indictor light will turn off.

1.

 Extend the antenna for better

signal reception. Move the

ON/OFF switch on the mini racer

to ON, and place it on the ground.

2.

 The remote controller is full-function:

   (1) The signal indicator lights up when

any button on the remote controller is

pressed.

   (2) Press the “up” arrow or the ‘down”

arrow on the remote controller to move

the mini racer forward or in reverse.

   (3) Press the “left” or the “right” arrow

on the remote controller while the mini

racer is moving to turn right or left.

n

Note: The directional guide is used to adjust the

mini racer’s alignment.

SKU 1672765

Save these instructions and packaging.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or experienced radio/TV technician for help.

Hobby Lobby Stores, Inc. • Oklahoma City, OK 73179 • www.hobbylobby.com