LEDVANCE LLC LDVA19C Manuel D’Utilisation
Multi
A
ZNP 3419592
E22206
PANTONE 021
3”x4”
3
LITHO
WCT71 Damp-Non
DimWireless-NotEnclosed
-AddedWeight
5/18/17
Jodi
PANTONE 431
To avoid personal injury and/or possible product damage, the
following cautions must be followed:
following cautions must be followed:
•
Risk of electrical shock. Disconnect power at fuse or circuit
breaker before installing or servicing.
•
To prevent early lamp failure, lamp should only be installed in
operating environments ranging between:
-20°C and +40°C (-4°F and +104°F)
-20°C and +40°C (-4°F and +104°F)
•
Suitable for damp locations.
•
Not for use with dimmers.
•
Lamp dims via wireless control and will not operate with a
dimmer switch.
•
Not for use in totally enclosed luminaires.
•
Not for use in emergency light fixtures or exit signs.
•
Ensure fixture can support the added weight of the lamp/bulb.
WARNINGS AND CAUTIONS
LIMITED WARRANTY
The manufacturer warrants the product to be free from defects in
materials and workmanship for two (2) years from date of
purchase when used as directed. Failure to comply with Product
warnings shall void the warranty. This warranty does not cover
Product subject to accident, neglect, abuse, misuse, or acts of
God. If Product fails to operate according to the warranty, the
manufacturer will replace Product with the same or similar
Product, at no charge. Product should be returned, together with
proof of date of purchase, to the retail store where Product was
purchased. For additional information, contact 1-800-654-0089;
Fax: 866-632-9674; Email: warranty.service@sylvania.com. THIS
IS THE EXCLUSIVE REMEDY AVAILABLE. LIABILITY FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY
EXCLUDED. SOME STATES AND JURISDICTIONS DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE
OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR
PROVINCE. THIS WARRANTY APPLIES TO CUSTOMERS
PURCHASING THE PRODUCT FOR RESIDENTIAL USE ONLY.
materials and workmanship for two (2) years from date of
purchase when used as directed. Failure to comply with Product
warnings shall void the warranty. This warranty does not cover
Product subject to accident, neglect, abuse, misuse, or acts of
God. If Product fails to operate according to the warranty, the
manufacturer will replace Product with the same or similar
Product, at no charge. Product should be returned, together with
proof of date of purchase, to the retail store where Product was
purchased. For additional information, contact 1-800-654-0089;
Fax: 866-632-9674; Email: warranty.service@sylvania.com. THIS
IS THE EXCLUSIVE REMEDY AVAILABLE. LIABILITY FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES IS EXPRESSLY
EXCLUDED. SOME STATES AND JURISDICTIONS DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE
OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR
PROVINCE. THIS WARRANTY APPLIES TO CUSTOMERS
PURCHASING THE PRODUCT FOR RESIDENTIAL USE ONLY.
1
4
3
2
E22206
Federal Communication Commission
Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution:
Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate this equipment. This transmitter must
not be co-located or operated in conjunction with any other
antenna or transmitter. For more information go to
www.sylvania.com/fccpart15b.
user's authority to operate this equipment. This transmitter must
not be co-located or operated in conjunction with any other
antenna or transmitter. For more information go to
www.sylvania.com/fccpart15b.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator and your body.
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator and your body.
Note:
The country code selection is for
non-US model only and is not available to all US model. Per FCC
regulation, all WiFi product marketed in US must fixed to US
operation channels only.
regulation, all WiFi product marketed in US must fixed to US
operation channels only.
Industry Canada statement:
This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie
Canada applicable aux appareils radio exempts de licence. Son
fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2)
ce dispositif doit accepter tout brouillage reçu, y compris un
brouillage susceptible de provoquer un fonctionnement indésirable.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie
Canada applicable aux appareils radio exempts de licence. Son
fonctionnement est sujet aux deux conditions suivantes:
(1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2)
ce dispositif doit accepter tout brouillage reçu, y compris un
brouillage susceptible de provoquer un fonctionnement indésirable.
LED
light bulb
10W • 800 lumens
Black