Intel i5-2520M FF8062700840017 Manuel D’Utilisation
Codes de produits
FF8062700840017
Power Management
50
Datasheet
4.3.2.2
Conditional Self-Refresh
The processor conditionally places memory into self-refresh in the package C3 and C6
low-power states.
When entering the Suspend-to-RAM (STR) state, the processor core flushes pending
cycles and then enters all SDRAM ranks into self refresh. In STR, the CKE signals
remain LOW so the SDRAM devices perform self-refresh.
The target behavior is to enter self-refresh for the package C3 and C6 states as long as
there are no memory requests to service. The target usage is shown in
.
4.3.2.3
Dynamic Power Down Operation
Dynamic power-down of memory is employed during normal operation. Based on idle
conditions, a given memory rank may be powered down. The IMC implements
aggressive CKE control to dynamically put the DRAM devices in a power down state.
The processor core controller can be configured to put the devices in active power down
(CKE deassertion with open pages) or precharge power down (CKE deassertion with all
pages closed). Precharge power down provides greater power savings but has a bigger
performance impact, since all pages will first be closed before putting the devices in
power down mode.
If dynamic power-down is enabled, all ranks are powered up before doing a refresh
cycle and all ranks are powered down at the end of refresh.
4.3.2.4
DRAM I/O Power Management
Unused signals should be disabled to save power and reduce electromagnetic
interference. This includes all signals associated with an unused memory channel.
Clocks can be controlled on a per SO-DIMM basis. Exceptions are made for per SO-
DIMM control signals such as CS#, CKE, and ODT for unpopulated SO-DIMM slots.
The I/O buffer for an unused signal should be tri-stated (output driver disabled), the
input receiver (differential sense-amp) should be disabled, and any DLL circuitry
related ONLY to unused signals should be disabled. The input path must be gated to
prevent spurious results due to noise on the unused signals (typically handled
automatically when input receiver is disabled).
Table 17.
Targeted Memory State Conditions
Mode
Memory State with Internal Graphics
Memory State with External Graphics
C0, C1, C1E
Dynamic memory rank power down based on
idle conditions.
idle conditions.
Dynamic memory rank power down based on
idle conditions.
idle conditions.
C3, C6
If the internal graphics engine is idle and there
are no pending display requests when in single
display mode, then enter self-refresh.
Otherwise use dynamic memory rank power
down based on idle conditions.
are no pending display requests when in single
display mode, then enter self-refresh.
Otherwise use dynamic memory rank power
down based on idle conditions.
If there are no memory requests, then enter
self-refresh. Otherwise use dynamic memory
rank power down based on idle conditions.
self-refresh. Otherwise use dynamic memory
rank power down based on idle conditions.
S3
Self-Refresh Mode.
Self-Refresh Mode.
S4
Memory power down (contents lost).
Memory power down (contents lost)