Honeywell 46-00868 Manuel D’Utilisation

Page de 64
 
 
32 
S
CANNER 
O
PERATION
 
 
I
NDICATOR 
D
ESCRIPTIONS
 
 
Audible 
When the 7820 scanner is in operation, it provides audible feedback.  These 
sounds indicate the status of the scanner.  Eight settings are available for the 
tone of the beep (normal, 6 alternate tones and no tone).  To change the tone, 
use the Tone Button or refer to the MetroSelect Configuration Guide. 
 
One Beep 
When the scanner first receives power, the blue LED will turn on 
and the scanner will beep once.  The blue LED will remain on for 
the duration of the beep.  The scanner is now ready to scan. 
 
When the scanner successfully reads a bar code, the blue LED will 
flash and the scanner will beep once (if configured to do so).  If the 
scanner does not beep once and the blue LED does not flash, then 
the bar code has not been successfully read. 
 
Two Beeps 
The scanners programmed interface setting does not match the 
actual connected interface cable.  This audible indicator will be 
heard during power up, or when a bar code is scanned. 
 
Razzberry Tone 
This is a failure indicator. Refer to failure modes on page 34.  
 
Three Beeps - during operation 
When placing the scanner in program mode, the blue LED will flash 
while the scanner simultaneously beeps three times. The blue LED 
will continue to flash until the unit exits program mode. Upon exiting 
program mode, the scanner will beep three times and the LED will 
stop flashing.  
 
When configured, three beeps can also indicate a communications 
timeout during normal scanning mode.   
 
The scanner will beep three times in an ascending tone, with each 
beep higher in pitch than the previous.  This tells the user that the 
single configuration bar code has successfully configured the 
scanner. 
 
Three beeps will also occur during a manual adjustment of the 
beeper tone.  The scanner will emit three evenly pitched/spaced 
tones with the blue indicator LED blinking in unison. 
 
Three Beeps - on power up 
This is a failure indicator. Refer to failure modes on page 34.