Intel Z520PT CH80566EE014DT Fiche De Données
Codes de produits
CH80566EE014DT
Electrical Specifications
34
Datasheet
Table 6. Processor Absolute Maximum Ratings
Symbol
Parameter
Min.
Max. Unit
Notes
1
T
STORAGE
Processor Storage Temperature
-40
85
°
C
2, 3, 4
V
CC, VCCP, VCCPC6
Any Processor Supply Voltage
with Respect to V
SS
-0.3
1.10
V
5
VCCA
PLL power supply
-0.3
1.575
V
VinAGTL+
AGTL+ Buffer DC Input Voltage
with Respect to V
SS
-0.1
1.10
V
VinAsynch_CMOS CMOS Buffer DC Input Voltage
with Respect to V
SS
-0.1
1.10
V
NOTES:
1.
For functional operation, all processor electrical, signal quality, mechanical and thermal
specifications must be satisfied.
2.
Storage temperature is applicable to storage conditions only. In this scenario, the
processor must not receive a clock, and no lands can be connected to a voltage bias.
Storage within these limits will not affect the long term reliability of the device. For
functional operation, refer to the processor case temperature specifications.
3.
This rating applies to the processor and does not include any tray or packaging.
4.
Failure to adhere to this specification can affect the long term reliability of the
processor.
5.
The V
CC
maximum supported by the process is 1.2 V but the parameter can change
(burn in voltage is higher).
3.12
Processor DC Specifications
The processor DC specifications in this section are defined at the processor core
4 for the pin signal definitions and signal
pin assignments. Most of the signals on the FSB are in the AGTL+ signal group. The
DC specifications for these signals are listed in Table 11. DC specifications for the
CMOS group are listed in Table 12.
Table 11 through Table 13 list the DC specifications for the processor and are valid
only while meeting specifications for junction temperature, clock frequency, and input
voltages. The Highest Frequency Mode (HFM) and Lowest Frequency Mode (LFM) refer
to the highest and lowest core operating frequencies supported on the processor.
Active mode load line specifications apply in all states except in the Deep Sleep and
Deeper Sleep states. V
CC,BOOT
is the default voltage driven by the voltage regulator at
power up in order to set the VID values. Unless specified otherwise, all specifications
for the processor are at T
J
= 90 °C. Care should be taken to read all notes associated
with each parameter.