Omnitron iConverter RS232 8767-2 Fascicule

 

■ Managed Serial RS-232 to fiber media converter with 

automatic baud rate detection

 

■ Supports baud rates ranging from 110 to 921,600 baud

 

■ Supports multimode, single-mode and single-fiber with 

ST, SC and LC connectors

 

■ Supports distances up to 5km on multimode and 120km 

on single-mode

 

■ Supports DB-9 and Terminal Block connector options 

for serial RS-232 interface

 

■ DIP-switch configuration of DTE or DCE device for easy 

connection to serial devices

 

■ Supports RTS, CTS, DCD, DTR and DSR controls

 

■ Features remote fiber loopback switch for easy testing 

of fiber link, even during serial transmission

 

■ Management is available with the addition of a 

management module to the chassis

 

■ SNMP management via NetOutlook

 provides real-

time port and module information, remote parameter 

configuration and trap notification

 

■ Modules are hot-swappable in 19-Module, 5-Module,  

2-Module or 1-Module chassis

 

■ Lifetime Warranty and free 24/7 Technical Support

The Omnitron iConverter RS232 is a managed serial RS-232 to 

fiber converter that transmits serial protocol over fiber media.  

Fiber transmission extends the serial signals up to 120km, and 

is immune from electrical and magnetic interference.
The RS232 supports single-mode, multimode, and single-fiber.  

The serial port interface is available with either a DB-9 female 

connector or terminal block connector for field wiring.
The RS232 automatically detects the signal baud rate of the 

connected serial device, ranging from 110 to 921,600 baud.  

It  also  automatically  adjusts  to  changes  in  the  connected 

device’s  baud  rate  during  operation  without  reconfiguration 

or interruption of service.
Connection to DTE or DCE devices is configured by an easily 

accessible DIP-switch on the front-panel of the module.  This 

feature eliminates the need to use a null-modem cable when 

connecting two serial devices of the same type.
A built-in Fiber Loopback DIP-switch provides easy validation of 

the entire fiber segment without interrupting fiber operations.
iConverter  RS232  modules  are  hot-swappable  and  can  be 

mounted in a 19-Module (2U high) or 5-Module (1U high) rack-

mountable chassis (19-inch or 23-inch) with any combination 

of redundant  AC, 24VDC or 48VDC power supplies. They 

can  also  be  mounted  in  a  2-Module AC  or  18  to  60VDC  

powered chassis, or in a 1-Module AC/DC powered chassis.

The  iConverter  family  of  managed  fiber  access  media 

converters are used in Service Provider access networks and 

Enterprise LANs. iConverter media converters provide fiber 

connectivity with copper to fiber, multimode fiber to single-mode 

fiber, or dual fiber to single-fiber conversions.