Troy-Bilt CSV206 Manuel D’Utilisation

9

This chipper shredder vacuum is equipped with front 
caster wheels. The casters can be locked in a straight 
ahead position or to swivel freely. 

•

Lift and place pins in the larger holes for locked or 
straight ahead operation. See Figure 8.

a. Place pins in smaller holes to allow casters to 

rotate freely. 

b. Lock wheels in straight position when 

operating on slopes. 

The nozzle adjustment levers are located on each side 
of the nozzle door. The nozzle door can be adjusted to 
one of five positions, ranging from 1/2” to 3” ground 
clearance, to provide best performance. 

•

Slide the height adjustment lever forward or 
backward for adjusting the nozzle door upwards or 
downwards. Height must be adjusted equally. In 
general, raise the nozzle to vacuum a thick layer of 
leaves and lower the nozzle for smooth surfaces. 
See Figure 9.

Adjust the drive clutch control if: 

a. the chipper shredder vacuum moves forward 

with the drive clutch control disengaged, 

b. it does not self-propel with the drive clutch 

control engaged, or

c.

drive belt is slipping (unit hesitates while 
engine maintains the same speed). 

•

Use the adjustment wheel located in the clutch 
control housing to tighten or loosen the clutch 
cable. 

•

In addition, the adjustment wheel may also be used 
to determine the position in which the drive clutch 
control is engaged. If it is more comfortable to have 
the drive engaged with the lever further away from 
the handle, tighten the clutch cable. See Figure 10.

Do not at any time make any 

adjustments without first stopping engine, 
disconnecting spark plug wire, and grounding it 
against the engine.