Troy-Bilt c3x-d3x Manuel D’Utilisation

When removing the cutting blade for 

sharpening or replacement, protect your hands with 

a pair of heavy gloves or use a heavy rag to hold the 

blade. 

Periodically inspect the blade adapter for cracks, especially if you 

strike a foreign object. Replace when necessary. Follow the steps 

below for blade service.
1. 

Disconnect spark plug boot from spark plug. Turn mower 

on its side making sure that the air filter and the carburetor 

are facing up.

2. 

Remove the bolt and the blade bell support which hold the 

blade and the blade adapter to the engine crankshaft. See 

Figure 7-1.

3. 

Remove blade from the adapter for testing balance. 

4. 

Balance the blade on a round shaft screwdriver to check. 

Remove metal from the heavy side until it balances evenly. 

When sharpening the blade, follow the original angle of 

grind. Grind each cutting edge equally to keep the blade 

balanced.

An unbalanced blade will cause 

excessive vibration when rotating at high speeds. It 

may cause damage to mower and could break 

causing personal injury.

5. 

Place the blade on the adapter such that the side of the 

blade marked “Bottom” (or with part number) faces the 

ground when the mower is in the operating position. Make 

sure that the blade is aligned and seated on the blade 

adapter flanges. See Figure 7-1 inset.

6. 

Place blade bell support on the blade. Align notches on the 

blade bell support with small holes in blade.

7. 

Replace hex bolt and tighten hex bolt to torque: 450 in. lbs. 

min., 600 in. lbs. max.

To ensure safe operation of your mower, periodically check the 

blade bolt for correct torque.

NOTE: Several components must be removed in order to change 

the mower’s belt. See an authorized Service Dealer to have your 

belt replaced.