Troy-Bilt RZT Manuel D’Utilisation

Never operate the mower deck 

without the chute deflector installed and in the 

down position. 

The discharge chute deflector must be installed before operating 

the mower. 
1. 

Remove the keys that are attached with a zip tie to the 

chute bracket.

2. 

Remove the flange lock nuts from the deck. Do not remove 

the push nuts or carriage bolts, leaving them in place will 

aid in installing the chute. See Figure 3-5.

3. 

Install the discharge chute deflector using the carriage 

bolts, push nuts and flange lock nuts as shown in Figure 

3-6 and securely tighten the hardware.

To adjust the position of the seat, rotate the seat forward and 

locate the clamp knob on the front left of the seat pan. Refer to 

Figure 3-2.
Rotate the clamp knob to the left and remove it, slide the seat 

forward or backward and re-insert the clamp knob into one of the 

four available positions on the seat pan and into the seat, then 

tighten securely. Make sure the seat is locked into position before 

operating the tractor. See Figure 3-7.