Troy-Bilt Series RZT Manuel D’Utilisation

• 

One RZT L Tractor

• 

One Oil Drain Tube

• 

One Deck Wash Hose Coupler 

• 

One Tractor Operator’s Manual

• 

One Engine Operator’s Manual

NOTE: This Operator’s Manual covers several models. Tractor 

features may vary by model. Not all features in this manual are 

applicable to all tractor models and the tractor depicted may 

differ from yours.

1.  Engage the transmission bypass rods, one on each side of 

the tractor, to move the tractor manually without starting it. 

The transmission bypass rods are located on the rear of the 

tractor, just inside each rear wheel. Engage the bypass rods 

by pulling each one out (a) and to the right (b) to lock it into 

place. See Figure 3-1.

2.  Disengage the bypass rods by reversing steps a & b after 

moving the tractor. See Figure 3-1.

3.  Remove the deck wash system nozzle adapter from the 

manual bag and store for future use.

To install the seat proceed as follows:

NOTE: The seat is shipped with the seat switch and seat 

pan attached.

1. 

Cut any straps securing the seat assembly and the drive 

control levers to the tractor. Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting 

the seat and the seat switch.

2. 

Remove the two shoulder screws and flange lock nuts in 

the seat pan as shown in Figure 3-2.

3. 

Rotate the seat into position and secure the seat into place 

with the previously removed shoulder screws and flange 

lock nuts. Be careful not to crimp or damage the wire 

harness while installing the seat. See Figure 3-2.
NOTE: Be sure to push the excess wire from the wire 

harness into the seat box hole before continuing.