Troy-Bilt LS338 Manuel D’Utilisation

5

•

Pry top, sides, and ends off the crate. Set panels 
aside to avoid tire puncture or personal injury.

•

Remove and discard plastic bag that covers unit.

•

Remove any loose parts if included with unit (i.e., 
operator’s manual, etc.)

•

Cut and remove straps which secure parts to 
bottom of crate. Unbolt any remaining parts which 
may be bolted to the bottom of the crate.

1.

Reservoir Tank and Engine-Pump Assembly

2.

Engine-Pump Assembly Hardware

3.

Wedge, Beam and Cylinder Assembly

4.

Tongue Assembly

5.

Wheels

6.

Hitch Assembly

7.

Beam Support/Latch Bracket

8.

Log Cradle Brackets and Hardware

9.

Fenders

10. Adjustable Jack Stand Assembly
11. Tail Light Kit
12. Hub Cap (2)

•

Disconnect spark plug wire and ground against the 
engine to prevent unintended starting of the log 
splitter. To locate the spark plug, please refer to the 
engine manual, shipped seperately with the unit.

The beam support is already attached to the tongue 
before shipping. If not, follow instructions below:

•

Remove two hex bolts, lock washers, and hex nuts 
from the tongue. See Figure 2.

•

Place the beam support/latch bracket on the 
tongue and secure with the hardware just removed. 
Tighten securely. 

•

Remove four hex bolts, lock washers, and hex nuts 
that secure jack stand mounting brackets to the 
jack stand. See Figure 3.

•

Place the jack stand halfway between beam 
support/latch bracket and end of tongue.

Use extreme caution while 

unpacking this machine. Some components 
are very heavy and will require extra people or 
mechanical handling equipment to move.