Tunturi R60 Manuel D’Utilisation

Store the rowing machine in the storage position 
against a wall in such a way that the front frame 
cannot fall on anyone by accident. 

The device is shipped with a loop and 

a hook for securing the rowing machine properly 
in the storage position. Choose an appropriate 
storage site for your rowing machine next to a wall 
and attach the hook tightly to the wall at the right 
height. Lift the rowing machine to the storage 
position in front of the hook. Thread the loop 
provided with the rowing machine around the 
cross bar and attach the loop to the hook.  Do not 
climb on the rowing machine when it is in storage 
position!

 The R60 requires very little maintenance. 

Check, however, from time to time that all screws 
and nuts are tight. 

Clean the cycle with a damp cloth. Do not use 

solvents.

Never remove the protective covers.

Clean the inner surfaces of the rail if necessary 

so that the seat moves as smoothly and quietly as 
possible. If necessary, you may improve the seat 
movement by adding paraffin to the surface of the 
rails.

Meter batteries: A warning display reports when 
the batteries of the meter need to be replaced. 
Turn the meter carefully outward from the front 
frame so that you can remove the battery box 
cover on the back of the meter. Open the battery 
box cover carefully from its lower edge. Be careful 
not to damage the wires. Replace the batteries (4 
“C” batteries) in the battery box according to the 
markings. Replace the cover.

Pull-bar battery: If the pull-bar controls cease 
to respond completely, replace the battery 
(3V lithium cell CR2032). Open the cover of 
the battery box on the back of the pull bar by 
removing the attachment screw. Replace the 
battery; make sure you place it in the right 
direction inside the holder. Replace the cover.

Despite continuous quality control, defects and 
malfunctions caused by individual components 
may occur in the equipment. In most cases it’s 
unnecessary to take the whole device in for repair, 
as it’s usually sufficient to replace the defective part. 

If the equipment does not function properly 
during use, contact your Tunturi dealer 
immediately. Always give the model and serial 
number of your equipment. Please state also the 
nature of the problem, conditions of use and 
purchase date. 

If you require spare parts, always give the model, 
serial number of your equipment and the spare 
part number for the part you need. The spare part 
list is at the back of this manual. Use only spare 
parts mentioned in the spare part list.

Length ......................................... 200  cm
Width  .......................................... 48 cm
Height  .......................................... 56 cm
Weight  .......................................... 46 kg

The R60 meets the requirements of the EU’s 
EMC Directives on electromagnetic compatibility 
(89/336/EEC). This product therefore carries the 
CE label.

The R60 meets EN precision and safety standards 
(EN-957).

Due to our continuous policy of product 
development, Tunturi reserves the right to change 
specifications without notice. 

The instructions must be followed carefully 

in the assembly, use and maintenance of your 
equipment. The warranty does not cover damage 
due to negligence of the assembly, adjustment 
and maintenance instructions described herein. 
Changes or modifications not expressly approved 
by Tunturi Oy Ltd will void the user's authority to 
operate the equipment! 

R60.indd   9

R60.indd   9

2.3.2006   17:22:09

2.3.2006   17:22:09