Turbosound NUQ-12/DP Manuel D’Utilisation

Page de 4
Quickstart Guide 
NuQ series 
 
NuQ Series Quickstart Guide v1.2 - Page - 3 
network protocol among the networked devices and is carried over CAT5-type cables. Minimum system requirements are: 
PC with Pentium processor, Windows NT, 2000, XP, or Vista, CD ROM drive or internet access, RS232 or USB port 
 RS232:Connect your computer to the BvNet interface using a standard 9-pin serial cable. External power is required for 
RS232 operation and this should be supplied by the Linea Research Accessory Power Supply 
 USB: Connect your computer to the BvNet interface using a USB Type A to USB Type B cable. External power is not 
required when using USB 
 
Connect networked devices via RJ45 CAT5 cables 
 
Launch the TurboDrive™ software 
 
Application Authorisation: TurboDrive™ prompts for an Authorisation Code on the first launch which is PJLUWZ 
 
Select the COM port from Network > Com Port 
 
Click the Online toolbar button 
 
Click on one of the devices that appear in the tree view to Launch the panel 
 
When the progress bar indicates ready, adjust the controls as required 
Please refer to the TurboDrive™ User Guide for further information on networking. 
Mounting and Fixing 
NuQ series two-way cabinets are equipped with pole mount sockets for portable use on 35mm speaker stands or poles. 
Bass cabinets are equipped with pole mount receptacles that allow two-way cabinets to be mounted at the correct height.  
NuQ series cabinets can be suspended in permanent installations using optional shoulder eyebolts coupled to the internal 
rigging points provided. To install using eyebolts, remove the appropriate countersunk screws and replace them with 
eyebolts, which must have a thread length of at least 18mm. Use the rear rigging point to angle the cabinet for optimum 
room coverage. Cabinets may be hung upside down if required. 
Turbosound wall and ceiling brackets are optionally available for installing non-powered NuQ series cabinets. They are 
also compatible with OmniMount™ wall and ceiling brackets. Some examples are shown below. 
Model 
Wall Mount 
Flying Yokes 
Swivel 
brackets 
Swivel 
extenders 
OmniMount™ Eyebolts 
NuQ-6 n/a 
NuQ-FY6  NuQ-SB6 n/a 
n/a 
M8 
NuQ-8 WB-20B 
PB-55 
NuQ-FY8 NuQ-SB8 NuQ-SBE8 
20.5 
Series 
M10 
NuQ-10 WB-20B 
PB-55 
NuQ-FY10 NuQ-SB10 NuQ-SBE10 
60 
Series  M10 
NuQ-12 WB-55B 
PB-55 
NuQ-FY12 n/a 
n/a 
60 
Series  M10 
NuQ-15 WB-55B 
PB-55 
NuQ-FY15 n/a 
n/a 
120 
Series M10