Heath Zenith Hardwired Electronic Chime 598-1313-00 Manuel D’Utilisation

-2-

IMPORTANT: Proper installation requires a diode on the front 
door push button. See Diode Installation Instructions (page 5) 
after completing steps 1 through 13 below.
Note: Electrical work must be in accordance with national and local 
electrical codes. If in doubt, consult a qualified electrician.
1.  Verify transformer power rating. Power must be supplied from 

a 16 Volt AC, 10 Watt or a 16 Volt AC, 15 Watt transformer 
(Heath

®

/Zenith models 122C, 121AC, or 125C).

2.  Remove cover from existing chime.
3.  Label all wires before disconnecting. Using masking tape,  mark 

each wire according to existing chime terminal markings.
•  “F” – Front Push Button Wire
•  “T” – Transformer Wire
•  “R” – Rear Push Button Wire (

Note: Some installations may 

not include rear door push button.)

4.  Disconnect all wires from existing chime.
5.  Remove existing chime base from wall.
6.  Determine  proper  chime  base  orientation.  The  chime  cover 

style will determine orientation.

7.  A cover pin is installed on two sides of the chime base. After 

determining correct orientation, remove, turn over, and reinstall 
the cover pin located on top of chime base (see Figure 1).

Illustrations may vary from actual chime unit.

Cover Pin

Volume Control

Base Orientation 
Marking

Wire Entrance Hole

Front Door Tune Selection 
Switch (3 Selections or 
10 Selections
– Depending on Model)

Transformer and 
Push Button Wire 
Connections

Test Button

Get user manuals: 

See SafeManuals.com