Intelligent Computer Solutions CBDR-0406-000A Manuel D’Utilisation
Chapter 3 – Installation
15
• Internal PC Mounting using PC’s eS-ATA interface.
The following describes the basic steps for mounting and connecting the Super
DriveLock in a PC using the PC’s eS-ATA interface.
DriveLock in a PC using the PC’s eS-ATA interface.
NOTE: For best results it is recommended to use the SDL unit connected to the
PC’s eSATA interface. The eSATA interface is designed primarily for
“hot swapping” drives.
“hot swapping” drives.
a. Power OFF the PC and remove the PCs cover.
b. Insert the Super DriveLock unit in an available 5 1/4” PC drive bay and secure
it using the supplied screws.
c. Insert the eSATA PCI or PCI-Express controller card in the PCs available PCI
or PCI-Express expansion slot.
eSATA PCI-Express
Figure 8
eSATA PCI
Figure 9
Internal S-ATA “Hot
Swap” Compatible
Interface
Swap” Compatible
Interface
External eSATA “Hot
Swap” Compatible
Interface
Swap” Compatible
Interface
Internal S-ATA “Hot
Swap” Compatible
Interface
Swap” Compatible
Interface
External eSATA “Hot
Swap” Compatible
Interface
Swap” Compatible
Interface