ZyXEL Wireless Access Point G1000 91-005-124003B Manuel D’Utilisation

G-1000 User’s Guide

48

Chapter 5 System Screens

To change your G-1000’s time and date, click the SYSTEM link under ADVANCED and 
then the Time Setting tab. The screen appears as shown. Use this screen to configure the G-
1000’s time based on your local time zone.

Figure 13   Time Setting

The following table describes the labels in this screen.

Table 11   Time Setting

Time Protocol

Select the time service protocol that your time server sends when you turn on 

the G-1000. Not all time servers support all protocols, so you may have to 

check with your ISP/network administrator or use trial and error to find a 

protocol that works.
The main difference between them is the format. 
Daytime (RFC 867) format is day/month/year/time zone of the server. 
Time (RFC 868) format displays a 4-byte integer giving the total number of 

seconds since 1970/1/1 at 0:0:0. 
The default, NTP (RFC 1305), is similar to Time (RFC 868). 
Select None to enter the time and date manually. 

Time Server Address

Enter the IP address or the URL of your time server. Check with your ISP/

network administrator if you are unsure of this information.

Current Time 

(hh:mm:ss)

This field displays the time of your G-1000.
Each time you reload this page, the G-1000 synchronizes the time with the 

time server.

New Time (hh:mm:ss) This field displays the last updated time from the time server.

When you select None in the Time Protocol field, enter the new time in this 

field and then click Apply.