Paxton Net2 Entry Single door kit 337-900-D Fascicule

Page 2

A desk mount stand is also available (PN: 337-847) 

See also

 

http://paxton.info/1896 >

Determine where the monitor will be sited.  The top right corner of the unit is regarded as the reference point for 

drilling and measurements. Screws and wall plugs are provided in the fitting kit. 

1. Determine the position of the top mounting screw. Drill the hole and tap in one of the No 8 wall plugs.

2. Put in one of the screws, leaving a suitable gap to the wall surface and slide the bracket over it.

3. Mark the hole positions for the lower 2 screws and the network cable entry.

4. Remove the bracket and drill the additional holes.

5. Tap in the other 2 wall plugs and hang the bracket back on the top screw. Secure the bracket with the 3 screws. 

Power is supplied via the network connection from a Net2 Entry controller or a network PoE switch. 

30 mm

79 mm

170 mm

55 mm

186 mm

88 mm

120 mm

53 mm

118 mm

℄

93 mm

A white network cable is supplied with the stand. 

Feed this through the mount and push it into the 

socket at the rear of the monitor.  Clip the mount to 

the monitor.