Zebra HW46211 Manuel D’Utilisation
13185L-002 Rev. A 1/24/06
110XiIIIPlus Maintenance Manual
Page 4-67
Maintenance
Section 4
Replace the Ribbon Take-Up Pulley
1. Refer to
. Turn the printer Off (O) and remove the AC
power cord and data cables.
2. Refer to
and remove the electronics cover.
3. Refer to
4. Refer to
. Remove the E-ring securing the pulley.
Figure 4-41. Replace the Ribbon Take-up Pulley
5. Slide the ribbon take-up pulley off the shaft.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Caution:
Wear protective eyewear when removing E-rings, C-clips, snap rings, and
springs. All of these are under tension and could fly off while being removed.
springs. All of these are under tension and could fly off while being removed.
Ribbon Take-Up
Pulley
E-Ring
Spacer
Flat Washer
Wave Washer